HoMedics OCTS-200 Instruction Manual And Warranty page 4

3. Attach the seat base mechanism to the underside of the seat
cushion using the included Allen wrench and 4 of the screws.
Make sure the arrow on the seat base mechanism is pointing
toward the front edge of the seat cushion (label on seat cushion).
Figure 4
4. Place the seat cushion on top of the pneumatic cylinder. Make sure
the cylinder is positioned properly by sitting on the seat cushion.
Figure 5
6
5. Attach the armrests (labeled as R and L for right and left sides) onto
the seat cushion using the included Allen wrench and 4 of the screws
(2 on each side). DO NOT TIGHTEN THE SCREWS COMPLETELY.
Figure 6
6. Connect remote arm wires to chair wires and feed into the opening
in the side of the chair.
Figure 7A Figure 7B
7