Assembly - Power Wheels L2170 Owner's Manual

• Plug the charger connector into the battery
• Plug the charger into a standard wall outlet. The power indicator
lights .
B
Notes:
- If power flow to the wall outlet is controlled by a switch, make sure
the switch is "ON".
- Use the charger only in a wall outlet. Do not plug the charger into
a ceiling outlet.
• Before first-time use, charge the battery for at least 18 hours.
Never charge the battery longer than 30 hours.
• Recharge the battery for at least 14 hours after each use of your
vehicle. Do not charge the battery longer than 30 hours.
• Once the battery is charged, disconnect the charger connector from
the battery. Unplug the charger from the wall outlet. The battery is
now ready to be installed in your vehicle. Please see the Battery
Installation section on page 15 for detailed instructions on installing
your battery. If your battery is already installed in your vehicle, simply
re-connect the motor harness connector to the battery.
The power indicator on
the charger does not
indicate the charge status
of your battery. The power
indicator allows you to
see that there is power
from the wall outlet.
B
A
Charger
Connector
.
A

ASSEMBLY

WARNING
Children can be harmed by small parts,
sharp edges and sharp points in the vehicle's
unassembled state, or by electrical items.
Care should be taken in unpacking and
assembly of the vehicle. Children should
not handle parts, including the battery,
or help in assembly of the vehicle.
Seat
1
• Insert the fastener end of a short seat belt strap up through the
slot near the outer edge of the seat. Make sure the side of the seat
belt with the fastener faces the outer edge of the seat.
• Pull the short seat belt strap completely through the slot until the
last T-loop at the opposite end of the belt catches against the slot.
You will pull one T-loop through the slot.
• Repeat this procedure to assemble the other short seat belt strap.
• Insert each fastener end of the long seat belt strap through each
slot in the center of the seat. Make sure the fasteners face the
outer edge of the seat.
• Pull each side of the long seat belt strap evenly through the slots.
Make sure to pull each T-loop through a slot.
8 8
Long Seat Belt
Short Seat Belts
L2170pr-0920 L2170pr-0920