Technical Specifications - Panasonic WV-CP230 Specifications

TECHNICAL SPECIFICATIONS

WV-CP230 Series
CCD Cameras
GENERAL SPECIFICATIONS
Pickup Device 768(H) x 494(V) pixels, interline transfer
CCD
Scanning Area
4.92(H) x 3.70(V)mm (equivalent to
Synchronization Internal/line lock/VD2 lock
Scanning System 2:1 interlace
Scanning 525 lines/60 fields/30 frames
Horizontal: 15.734kHz
Vertical: 59.94Hz
Horizontal Resolution 480 TV lines
Video Output 1.0Vp-p NTSC composite/75 ohms
(through specified circuit)
S/N Ratio 50dB (luminance S/N) (AGC off, weight on)
Electronic Light
Control
Equivalent to continuous variable shutter
speed between
Minimum Illumination 2.0 lux (0.2 fc) at f/1.4
AGC On only
Switch Controls For WV-CP230/CP234
Sync selection switch (LL/INT)
Electronic Light Control/Automatic Light Control selection switch (ELC/ALC)
Detail level selection switch (SOFT/SHARP)
Back light compensation on/off switch (BLC on/off)
Lens selection switch (VIDEO/DC)
ARCHITECTS' AND ENGINEERS' BID SPECIFICATIONS
WV-CP230
The digital processing color camera shall be a Panasonic Model WV-CP230 or equivalent. The camera shall feature a
transfer CCD pickup device with 380,000 [768(H) x 494(V)] pixels with a microlens on each pixel. The camera shall produce a horizontal
resolution of 480 lines and a signal-to-noise ratio of 50dB with 1H enhancement. The camera's Digital Signal Processing (DSP) shall
minimize aliasing and feature advanced digital back light compensation (BLC). The camera's Automatic Gain Control (AGC) shall
provide clear images in low light conditions. The camera shall display useable color pictures at a scene illumination of 2 lux (f/1.4). The
camera synchronization shall be internal, line-lock (phase adjustable) and VD2 (vertical drive lock). The video signal shall be
transmitted up to 3000' over coaxial cable (Belden 9259 or equivalent), when used with the Panasonic model WJ-FS616/WV-PB6164
multiplexer with control kit, Matrix System 500, Matrix System 850 and single camera controller, model WV-CU151. The camera lens
mount configuration shall accept both C- and CS-mount lenses, as well as both DC and video control voltage for ALC servo lenses, and
feature Electronic Light Control (ELC) (equivalent to continuous variable shutter speed between
the use of inexpensive fixed and manual iris lenses. The power source shall be 120VAC (4.1W). The camera shall be enclosed in an all
steel housing and shall be UL listed. The camera's dimensions shall not exceed 2
WV-CP232
The digital processing color camera shall be a Panasonic Model WV-CP232 or equivalent. The camera shall feature a
transfer CCD pickup device with 380,000 [768(H) x 494(V)] pixels with a microlens on each pixel. The camera shall produce a horizontal
resolution of 480 lines and a signal-to-noise ratio of 50dB with 1H enhancement. The camera's Digital Signal Processing (DSP) shall
minimize aliasing and feature advanced digital back light compensation (BLC). The camera's Automatic Gain Control (AGC) shall
provide clear images in low light conditions. The camera shall display useable color pictures at a scene illumination of 2 lux (f/1.4). The
camera synchronization shall be internal, line-lock (phase adjustable) and VD2 (vertical drive lock). The video signal shall be
transmitted up to 3000' over coaxial cable (Belden 9259 or equivalent), when used with the Panasonic model WJ-FS616/WV-PB6164
multiplexer with control kit, Matrix System 500, Matrix System 850 and single camera controller, model WV-CU151. The camera lens
mount configuration shall accept both C- and CS-mount lenses, as well as both DC and video control voltage for ALC servo lenses, and
feature Electronic Light Control (ELC) (equivalent to continuous variable shutter speed between
the use of inexpensive fixed and manual iris lenses. The power source shall be 12VDC (300mA). The camera shall be enclosed in an all
steel housing and shall be UL listed. The camera's dimensions shall not exceed 2
WV-CP234
The digital processing color camera shall be a Panasonic Model WV-CP234 or equivalent. The camera shall feature a
transfer CCD pickup device with 380,000 [768(H) x 494(V)] pixels with a microlens on each pixel. The camera shall produce a horizontal
resolution of 480 lines and a signal-to-noise ratio of 50dB with 1H enhancement. The camera's Digital Signal Processing (DSP) shall
minimize aliasing and feature advanced digital back light compensation (BLC). The camera's Automatic Gain Control (AGC) shall
provide clear images in low light conditions. The camera shall display useable color pictures at a scene illumination of 2 lux (f/1.4). The
camera synchronization shall be internal, line-lock (phase adjustable) and VD2 (vertical drive lock). The video signal shall be
transmitted up to 3000' over coaxial cable (Belden 9259 or equivalent), when used with the Panasonic model WJ-FS616/WV-PB6164
multiplexer with control kit, Matrix System 500, Matrix System 850 and single camera controller, model WV-CU151. The camera lens
mount configuration shall accept both C- and CS-mount lenses, as well as both DC and video control voltage for ALC servo lenses, and
feature Electronic Light Control (ELC) (equivalent to continuous variable shutter speed between
the use of inexpensive fixed and manual iris lenses. The power source shall be 24VAC, 60Hz (4.1W). The camera shall be enclosed in an
all steel housing and shall be UL listed. The camera's dimensions shall not exceed 2
1 ⁄ " Color
3
1 ⁄ " tube)
3
1 ⁄ – 1 ⁄ sec.
6 0 1 0,000
Color CCD Cameras
White Balance ATW (Auto Tracking White Balance)
control
Aperture Correction Selectable sharp or soft
Iris Selectable ELC or ALC
Back Light
Compensation Selectable normal or back light
compensation
Lens Mount Selectable C-/CS-mount
Ambient Operating
Temperature
10°F – 122°F (-10°C – +50°C)
Ambient Operating
Humidity Less than 90%
Power Source/ WV-CP230: 120VAC, 4.1W
Consumption WV-CP232: 12VDC, 300mA
WV-CP234: 24VAC, 4.1W
Dimensions
2 9 ⁄ "H x 2
1 6
(65 x 67 x 123m) (without lens)
Weight WV-CP230: 1.4 lbs. (0.62g)
WV-CP232: 0.98 lbs. (0.445g)
WV-CP234: 1.04 lbs. (0.470g)
Weights and dimensions shown are approximate.
Specifications subject to change without notice.
Switch Controls For WV-CP232
Electronic Light Control/Automatic Light Control selection switch (ELC/ALC)
Detail level selection switch (SOFT/SHARP)
Back light compensation on/off switch (BLC on/off)
Lens selection switch (VIDEO/DC)
1 ⁄ sec. and
6 0
9 ⁄ "H x 2 5 ⁄ "W x 4 13 ⁄ "D.
1 6 8 1 6
1 ⁄ sec. and
6 0
9 ⁄ "H x 2 5 ⁄ "W x 4 13 ⁄ "D.
1 6 8 1 6
1 ⁄ sec. and
6 0
⁄ "H x 2 ⁄ "W x 4 ⁄ "D.
9 5 13
1 6 8 1 6
5 ⁄ "W x 4 13 ⁄ "D
8 1 6
1 ⁄ " interline
3
1 ⁄ sec.) which allows for
1 5,700
1 ⁄ " interline
3
1 ⁄ sec.) which allows for
1 5,700
1 ⁄ " interline
3
1 ⁄ sec.) which allows for
1 5,700
35
®
4