Remove The Memory Card; Charge The Battery - Nokia 7610s User Manual

Get started
1. Remove the back cover.
2. Insert the memory card into the
memory card slot with the contact
surface facing down, and press it until
it locks into place.
3. Replace the back cover.

Remove the memory card

Important: Do not remove the memory card in the middle of an
operation when the card is being accessed. Removing the card in the middle
of an operation may damage the memory card as well as the device, and
data stored on the card may be corrupted.
You can remove or replace the memory card during phone operation
without switching the device off.
1. Ensure that no application is currently accessing the memory card.
2. Remove the back cover.
3. Press the memory card slightly in to release the lock, and remove it.
4. Replace the back cover.

Charge the battery

Your battery has been precharged, but the charging levels may vary.
1. Connect the charger to a wall outlet.
2. Connect the charger to the device.
3. When the battery is fully charged, disconnect
the charger from the device, then from the
wall outlet.
If the battery is completely discharged, it may
take a few minutes before the charging indicator
appears on the display or before any calls can be made.
The charging time depends on the charger used. Charging a BL-4S battery
with the AC-3 charger takes approximately 3 hour while the phone is in
the standby mode.
12
s