Programming Network Features; Activating The Network; Training Mode; System Reports - QUORION CR 1200 User Manual

7.5 Programming Network Features

7.5.1 Activating the Network

The network is activated by programming the REGISTER# in PARAMETER 53 and the
NETWORK PORT in PARAMETER 89. There are two types of network possible:
RS-232 NETWORK
When you want to connect only 2 registers in a network you can also use a RS-232
network using the standard RS-232 ports in your register. The NETWORK PORT for RS-
232 can be any port except PORT# 4 which is fixed for the RS-485 network. The
maximum BAUDRATE for PORT# 1, 3 & 4 is 57600 (PARAMETER 2, 4 or 5, value 6) and
the maximum BAUDRATE for PORT# 2 is 9600 (PARAMETER 3 value 3 o. It is advised to
use the highest possible baud rate.
RS-485 NETWORK
When you want to connect more then 2 registers in a network you MUST use a RS-485
network which means you also need an RS-485 card installed in your register. The
NETWORK PORT for RS-485 is fixed to PORT# 4 and the maximum BAUDRATE is
57600 (PARAMETER 5, value 6). Other possible baud rates are 38400 (value 5), 19200
(value 4). It is advised to use the highest possible baud rate.
The network can be used only for communication with the PC.

7.6 Training Mode

Training mode allows for training on the cash register without registering what has been
rung up. No reports will be affected by whatever has been rung up in Training Mode, and
every receipt that is produced in training will be printed with a training message. A hash (#)
will also appear on the left hand side of the display.
In order to access Training Mode, a pre-programmed training clerk must be activated.
Training mode will remain activated until a new clerk is assigned. Training clerks can either
be assigned in the ( R )egister or the ( P )rogramming position. Certain clerk flags permit
the changing of training clerks in the P position only.

8. System Reports

All reports, whether x, z, or any financial, report are freely customizable and programmable
by the user. Therefore, you will be able to include any information you consider essential.
You can call up reports by turning the control lock key into the appropriate lock position,
either X or Z. Upon positioning the key in the right location, the display will show a report
type. You can now use the up/down keys to parse the list of reports on the display.
Selection occurs when you enter the number of the report (shown to its right) followed by
the Subtotal Key to confirm your choice.
38