Advertisement
INITIAL TESTING OF YOUR HR30:
You're now ready to power up and test your HR30, but before you begin take
some time to sweep off your bench of any loose component leads or solder
splashes. A clean work area not only makes testing less frustrating but also
less prone to problems.
REQUIRED FOR INITIAL TESTING AND ALIGNMENT:
A known frequency standard in the 10MHz range such as:
•
Crystal oscillator or,
•
RF signal generator or,
•
Grid Dip oscillator or,
•
QRP transmitter such as a Ramsey QRP-30
•
A Ramsey frequency counter, CT-90 or,
•
Any accurately calibrated receiver covering 30 meters
•
At the least, personal familiarity with the 30 Meter Ham band
And the following:
•
Coil alignment tool ( can be homemade per directions) and
•
9-volt battery, antenna earphones or a small speaker.
Connect the following:
Fresh, 9-volt battery.
Earphone or speaker.
Antenna or at least a random length of wire.
Adjust the three controls to the middle of their ranges
Press the power switch "on". You should hear background noise
immediately, at least a gentle hiss.
See if the volume control does its job, vary it and notice how the volume
changes.
See if the RF gain control has some effect on what you hear.
If everything seems ok so far, feel the tops of the two IC's with your finger.
Neither should feel hot or warm
Slowly rotate the tuning control. At this point you may or may not hear
anything, since neither coil has been adjusted. If you do hear a few
whistles as you tune, the SA602 oscillator is working just fine.
HR30• 14
Advertisement
