Tips For Getting The Most From Your G11; A Note About The Ctcss Or Dcs Codes; Preparation; Batteries - Midland G-11 Owner's Manual

OWNER'S MANUAL FOR THE G-11 (GMRS)
TIPS FOR GETTING THE MOST FROM YOUR G-11
Due to the band of operation (462 MHz) the G11 provides communications that are virtually free
of atmospheric interference (skip) that is common on lower frequency bands. Along with this and
an antenna system that is very efficient, communications range is surprisingly good. Many times
the limit to maximum possible range is environmental factors such as blockage caused by trees,
buildings, hills, or other obstructions. If you find communication is not possible, many times this
can be overcome by moving only a few feet to a new location. Range is greatly reduced while
operating from a metal building or from a vehicle. Battery condition also affects range. The G11
operates on rechargeable Ni-MH batteries or alkaline batteries. While this unit has been designed
with gaskets for water resistance and ruggedness it is a precision piece of electronic equipment
that should not be exposed to water or handled carelessly. Normal care should result in years of
trouble free operation. Do not leave batteries installed over a long period of time as leakage may
occur, that can destroy the radio. If you experience problems operating the radio, turn off the
radio, press and hold the "F" button and turn on the radio. This will cause the radio to return to
the factory settings. Always save your receipt, as it is required for warranty consideration.
A note About CTCSS/DCS Codes
This radio incorporates 38 CTCSS (Continuos Tone Coded Squelch System) codes and 83 DCS
(Digital Coded Squelch) codes that, when activated, prevent the user from hearing other radios
that do not have the same code. These codes do not make your conversation private. If you
experience difficulties contacting or hearing other radios in your group make sure the CTCSS or
DCS code is set the same on all radios. If you are using the G11 where interference from other
radios or electrical devices are present, enabling the CTCSS or DCS codes will usually mute the
interference. Many times interference will be noticed by the presence of loud static from the
speaker.

PREPARATION

BATTERIES:

G11 radios operate with 4 AAA Alkaline, or Ni-MH (nickel metal hydride) batteries (optional) or at
reduced transmitter power with 3 AA Alkaline, Ni-Cad (Nickel Cadmium) or Ni-MH (nickel metal
hydride) batteries (optional). Alkaline AA batteries will provide about 45 hours of use, Ni-Cad
batteries will provide about 15 hours of use and Ni-MH batteries will provide about 24 hours of
use. Alkaline AAA batteries will provide about 15 hours of use and Ni-MH batteries will provide
about 10 hours of use. The G11 may be supplied with a wall charger. Ni-MH and Ni-Cad batteries
must be charged prior to use. Charge at least 10 hours with the standard charger. DO NOT
attempt to charge any type of Alkaline batteries in this radio.
Installing Batteries:
Hold the radio face down. Press the latch so it swings away from the cover.
1. Lift the battery cover slightly. Gently slide the cover off the unit.
2. Insert 4 AAA batteries observing the proper polarity.
Alternate option: remove AAA battery adapter insert. Insert 3 AA batteries observing the
proper polarity.
3. Replace the battery cover over the batteries and fasten with the latch.
http://www.midlandradio.comPage 4 of 16