Adjustments - Sanitaire SC6001 Owner's Manual

BRUSH AND PAD DRIVER
INSTALLATION
CAUTION: Disconnect the power cord from the electrical
outlet before installing a brush or pad driver.
ON
To install a brush or pad driver, leave the handle in the upright
position and tip the machine backwards so it rests on its
wheels and upper handle section (Fig. 4). The brush and
pad driver both attach in the same manner: align the cutouts
on the inner ring of the brush or pad driver with the tabs on
the inside of the ring of the drive hub. Push the brush or pad
driver firmly in position, then turn it counterclockwise until it
locks into place.
To remove, turn the brush or pad driver clockwise until it
stops, then lift it off.
NOTE: Always remove the brush or pad driver when the
machine is not in use.
OFF
Fig. 4

ADJUSTMENTS

DRIVE BELT ADJUSTMENT
CAUTION: Disconnect the power cord from the electrical
outlet before adjusting drive belt tension.
1. Remove screw that secures cover.
2. Loosen the bolts holding the drive motor to the frame; do
not remove (Fig.5)
3. Turn the three screws at the rear of the frame until the belt
is tight.
4. Test the machine. If belt slips, adjust further. Retest. If
the belt does not slip, tighten the drive motor bolts. DO
NOT overtighten the drive belt.
5. Replace cover and screw to secure.
Adjusting Bolts
Fig. 5 (view with cover off)
HANDLE ADJUSTMENT
The handle can be adjusted to any desired work position by
simply pushing up on the handle lock (Fig. 6). Move the handle
to the desired position, then firmly push down on the handle
lock which will lock the handle in position.
Unlock
Lock
Fig. 6
5