Switching The Mm 450-X On/Off - Sennheiser MM 450-X Instruction Manual

Putting the MM 450-X into operation
1
5
1
5
14 | MM 450-X

Switching the MM 450-X on/off

WARNING
Danger of hearing damage!
Listening at high volume levels for long periods can lead to perma-
nent hearing defects.
Before putting the headset on, set the volume to a low level.
Do not continuously expose yourself to high volumes.
Switching the MM 450-X on
Press the Master button
flashes blue. You hear an ascending beep.
– When switching the headset on
go into pairing mode.
The headset is waiting to be paired with a Bluetooth enabled device
(see page 12).
– When the headset is already paired with an audio
Bluetooth connection is automatically established.
You hear an ascending beep and then you hear your audio source.
– When the headset is already paired with an audio source
audio source is switched off
blue.
The headset will try for 3 minutes to connect to one of the up to
8 previously paired audio sources. If this fails, the headset automati-
cally switches off after 60 minutes.
Switching the MM 450-X off
Press the Master button
flashes 3 times red.
You hear a descending beep. The Bluetooth connection is automatically
deactivated. The headset switches off.
and keep it pressed until the
for the first time, it will automatically
or out of range, the
and keep it pressed until the
1
LED
source, the
but the
1
LED flashes
1
LED