Char-Broil 465640212 Product Manual

Char-Broil 465640212 Product Manual

Stainless steel tabletop grill

Advertisement

THIS GRILL IS FOR OUTDOOR USE ONLY.
DANGER
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid.
4. If odor continues, keep away from the appliance
and immediately call your gas supplier or your
fire department.
Failure to follow these instructions could result in
fire or explosion which could cause property
damage, personal injury or death.
WARNING
1. Do not store or use gasoline or other
flammable liquids or vapors in the vicinity of
this or any other appliance.
2. An LP cylinder not connected for use shall not
be stored in the vicinity of this or any other
appliance.
© 2012 Char-Broil, LLC • Columbus, GA 31902 • Printed in China • Assembly Instructions © 2012
Product Guide

Stainless Steel

Tabletop Grill
Model 465640212
For support and to register your grill,
please visit us at www.charbroil.com
If you have questions or need
assistance during assembly, please
call 1-800-241-7548.
IMPORTANT: Fill out the product record information below.
Serial Number
See rating label on grill for serial number.
Date Purchased
WARNING
This manual contains important information necessary
for the proper assembly and safe use of the appliance.
Read and follow all warnings and instructions before
assembling and using the appliance.
Follow all warnings and instructions when using the
appliance.
Keep this manual for future reference
CAUTION
Some parts may contain sharp edges — especially as
noted in the manual! Wear protective gloves if necessary.
INSTALLER/ASSEMBLER: Leave these instructions with
consumer.
CONSUMER: Keep this manual for future reference.
42804977 • 07-13-12

Advertisement

Table of Contents
loading

Summary of Contents for Char-Broil 465640212

  • Page 1: Product Record Information

    Product Guide Stainless Steel Tabletop Grill Model 465640212 For support and to register your grill, please visit us at www.charbroil.com If you have questions or need assistance during assembly, please call 1-800-241-7548. IMPORTANT: Fill out the product record information below.
  • Page 2: Table Of Contents

    TABLE OF CONTENTS DANGER Product Record Information ......1 1. Never operate this appliance unattended. Safety Symbols.
  • Page 3: Installation Safety Precautions

    Installation Safety Precautions USE AND CARE • Use grill, as purchased, only with LP (propane) gas and the regulator/valve assembly supplied. • Grill installation must conform with local codes, or in their WARNING absence of local codes, with either the National Fuel Gas Code, ANSI Z223.1/ NFPA 54, Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage and For Safe Use of Your Grill and to Avoid Serious...
  • Page 4 LP (Liquefied Petroleum Gas) Propane Cylinder Installation/Removal • Is nontoxic, odorless and colorless when produced. For Your Propane Cylinder Installation: Safety , LP gas has been given an odor (similar to rotten cabbage) so that it can be smelled. 1. Remove cap from end of Propane cylinder (sold separately). •...
  • Page 5: Spider Alert

    Match Lighting Instructions CAUTION Important! Raise lid to open position. Attempting to light burner with lid closed may cause an explosion. Do not expose any part of your body or clothing SPIDER ALERT! directly above cooking area when lighting. 1. Read all instructions before lighting. 2.
  • Page 6: Food Safety

    Grill Maintenance CAUTION - Allow grill to cool before cleaning. Frequency of cleaning is determined by how often grill is used. • Putting out grease fires by closing the lid is not possible. Grills are well ventilated for safety reasons. - DO NOT use self-cleaning oven to clean any grill part.
  • Page 7: Limited Warranty

    LIMITED WARRANTY This warranty only applies to units purchased from an authorized retailer. Manufacturer warrants to the original consumer-purchaser only that this product shall be free from defects in workmanship and materials after correct assembly and under normal and reasonable home use for the periods indicated below beginning on the date of purchase*.
  • Page 8: Parts List/ Parts Diagram

    Parts List Description Description GRILL LID, W/ TOP HINGES FLAME TAMER SUPPORT COOKING GRATE GREASE TRAY RAIL FLAME TAMER GREASE TRAY HEAT SHIELD LEG, RIGHT FRONT, F/ IGNITOR FIREBOX LEG, LEFT REAR BURNER ASSEMBLY LEG, RIGHT REAR, LEFT FRONT HINGE, F/ GRILL LID, BOTTOM IGNITOR SIDE HANDLE ELECTRODE, W/ WIRE...
  • Page 9: Assembly

    Assembly Open lid and remove all parts packed inside the grill. Using 8 M6 x 10mm screws, 8 m6 lock washers and 8 M6 flat washers, install the legs onto the firebox as shown. NOTE: the leg with the large igniter mounting hole must be on the front, RH side. CAUTION Some parts may contain sharp edges! Wear protective gloves if necessary.
  • Page 10 Assembly (Con’t.) Bezel Attach the lid handle and handle bezels to the lid using Handle 2 handle sleeves and 2 M6x20mm screws as shown Sleeve Remove the igniter nut from the pushbutton igniter. Insert the pushbutton igniter through the mounting hole in the right, front leg.
  • Page 11 Assembly (Con’t.) - Before assembly, inspect Regulator for damage, dirt or debris accumulation. Clean out if present. - With knob pointing down, insert Regulator/Valve into end of Burner. Notch in Regulator/Valve MUST engage dimple in end of Burner. Rotate clockwise to lock - Once Regulator/Valve has completely engaged Burner, turn Regulator/Valve clockwise to lock in position with knob pointing Regulator/Valve...
  • Page 12 NOTES:...
  • Page 13: Troubleshooting

    EMERGENCIES: If a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department. Emergencies Possible Cause Prevention/Solution Gas leaking from LP •Mechanical failure due to rusting or •Replace LP cylinder. cylinder. mishandling. Grease fire or •...
  • Page 14: Hardware List

    Troubleshooting (continued) Problem Possible Cause Prevention/Solution Burner(s) will not light using ignitor. •Push-button sticks at bottom. •Replace ignitor. •Sparking between ignitor and electrode. •Inspect wire insulation and proper connection. Replace wires if insulation is broken. Burner(s) will not •See “GAS ISSUES:” on previous page. match light.

Table of Contents