For Discount White Outdoor Parts Call 606-678-9623 or 606-561-4983
8.
FUEL SYSTEM
CAUTION: When working around the fuel sys-
tem, do not bring any sources of heat, spark, or
open flame close enough to the work are to pose
a fire hazard.
•
Drain the fuel tank or clamp the fuel line before
starting work to prevent spillage.
•
Dispose of drained fuel in a safe and responsible
manner.
8.1.
The fuel tank is secured to a bracket on the back
of the engine by a screw and fender washer,
removable with a 12mm wrench, and a second
bolt,
removable
See Figure 8.1.
Screw
Figure 8.1
8.2.
To remove the fuel tank:
•
Drain the tank.
•
Disconnect the fuel line from the tank.
•
Remove the fuel cap.
•
Unbolt, and remove the tank.
with
a
10mm
wrench.
Screw and
fender washer
www.mymowerparts.com
MTD Engine - Series 350/450/650
8.3.
The
tank
is
See Figure 8.3.
Tank
Cap liner / gasket
Filter
Cap
Sleeve (mtg. hole)
8.4.
To test the cap vent, a hand-pumped vacuum /
pressure tester may be connected to the fuel
barb (after draining). See Figure 8.4.
21
vented
through
the
Hose barb
Figure 8.3
Hand-pump vacuum
/ pressure tester
connected to fuel line
Figure 8.4
cap.