Adjustment / Settings - Canon PIXMA MP500 Service Manual

3-3. Adjustment / Settings

(1) Paper feed motor adjustment
Perform the following adjustments when the paper feed motor unit is replaced:
1) When attaching the motor, fasten the screws so that the belt is properly stretched (in the direction indicated by
the blue arrow in the figure below).
2) After replacement, be sure to perform the service test print, and confirm that no strange noise or faulty print
operation (due to dislocation of the belt or gear, or out-of-phase motor, etc.) occurs.
Note: The red screws securing the paper feed motor may be loosened only at replacement of the paper feed motor
unit. DO NOT loosen them in other cases.
(2) Grease application
1) Machine unit
No Part name
Chassis
1 (1)
Ass'y
Chassis
2 (2)
Ass'y
Adjust
3 (3)
Plate L
Chassis
4 (4)
Ass'y
Chassis
5 (5)
Ass'y
6 CR Shaft (6) Entire surface of the carriage
Where to apply grease / oil
Entire surface the carriage
slider contacts
PR lift shaft cam contact
portion (at 3 locations)
Carriage shaft cam L sliding
portion
Carriage shaft sliding
portion on the left side of
chassis(at 2 locations)
Carriage shaft sliding
portion on the right side of
chassis(at 2 locations)
shaft where the carriage unit
Grease / oil Grease / oil
name amount
Floil
27 to 54 mg
KG107A
Floil
9 to 18 mg
KG107A
Floil
18 to 36 mg
KG107A
Floil
9 to 18 mg
KG107A
Floil
9 to 18 mg
KG107A
Floil
1-25
Number
of drops*
200 to 400
Number
of
locations
to apply
grease /
oil
3 1
1 3
2 1
1 2
1 2
1