Table of Contents
Advertisement
Basic operations
To project 1
1
_
5 7 4 2
m
5_
j4
1
Turn on the main power switch of the projector [ I: ON].
• The Power indicator lights orange.
2
Press the STANDBY / ON button.
• The Power indicator will blink green and then light green.
• The green blinking indicates
warmup.
• After the power is turned on, the lamp will be cooled for approximately
1 rain. and the power cannot
be turned on even by pressing the STANDBYJON
button.
3
Remove
the lens cap.
4
Use the ZOOM button to adjust the screen size.
5
Use the FOCUS button to adjust the focus.
( 1) The display shown to the right will appear when the FOCUS button is pressed.
+ + + FOCUS+ + +
(2) Use the FOCUS button to adjust the focus until the image is sharp.
(3) The message "Focus" will disappear if any other button is pressed.
• (When there is no input signal, the Focus characters are not displayed when the input signal is outside the sync range.)
6
Turn on the power to the connected equipment.
Refer to page 31 concerning
the connection
of other equipment.
7
Press
either
the
INPUT
button
of the
projector
or the VIDEO/RGB
button
of the
remote
control
to select
the signal
to be
projected on the screen.
The selected signal input channel will be displayed in the lower right part of the screen.
Exampleon-screendisplay
RGB 1
13
Advertisement
Table of Contents
