Operation - Ryobi HP40L Operator's Manual

WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side
shields when operating products. Failure to do so could
result in objects being thrown into your eyes, resulting in
possible serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Driving screws with screwdriver bits
 Light-duty drilling
TO CHARGE
See Figure 2.
When charging the screwdriver, a red charge light will
illuminate on the handle of the screwdriver. This red charge
light will go off when the screwdriver is fully charged.
 Insert charger plug into input jack making sure it is
properly connected.
 Charger can be used with normal household voltage of
120 volts and 60 Hz.
 Connect charger to power supply.
 After normal usage, a minimum of 3 hours of charging
time is required to fully recharge the screwdriver.
 Do not place charger in an area of extreme heat or cold.
It will work best at normal room temperature.
 Remove the product from the charger once it is fully
charged and ready for use.
WARNING:
Battery products are always in operating condition.
Therefore, the switch should always be locked when not
in use or carrying at your side.

OPERATION

TO INCREASE
TORQUE
TO DECREASE
ADJUSTABLE TORQUE CLUTCH
This screwdriver is equipped with an adjustable torque clutch
for driving different types of screws into different materials.
The proper setting depends on the type of material and the
size of screw you are using.
10
RED
CHARGE LIGHT
CHARGER PLUG
CHARGER
TORQUE
ADJUSTMENT RING
ARROW
TORQUE
INPUT
JACK
Fig. 2
Fig. 3