Tascam 2488 Reference Manual page 23

No. Message
No locate
markers have
been set. Use
17
INSERT MARK.
Press [EXIT].
No master track
found. Use
PRE-MASTERING
18
to create one.
Press [EXIT].
No MIDI player
selected. Use
MIDI PLAYER
19
to select.
Press [EXIT].
No tracks have
been armed. Arm
at least one
20
track.
Press [EXIT].
Non-linear
audio detected.
Check your
21
system set-up
Press [EXIT].
Not enough free
disk space. Use
22
DELETE UNUSED
to make space.
Press [EXIT].
Not enough free
memory. Use
DELETE UNUSED
23
to free memory.
Press [EXIT].
Not enough room on
CD for burn. Use
24
another CD [YES]
or cancel [NO].
Meaning
Because there are no locate markers
currently set, a location command cannot be
performed.
There is no master track available for making
an audio CD.
An attempt has been made to play back the
MIDI track with the MIDI PLAYER mode set to
OFF.
Before an auto-punch operation, you must
have at least one armed track.
Digital audio input mode has been selected,
but the 2488 has detected the wrong data
format for the incoming digital audio to be
used.
Copying a song has failed because there is
not enough space on the selected or target
partition.
Sometimes after repeated operations, the
internal memory of the 2488 becomes used,
and recording, etc. is not possible.
Too much data has been selected to fit onto
the CD that is currently loaded.
5 – Error and status messages
Action
Press EXIT, and use the INSERT or SET
LOC key from the home screen to add some
locate markers at the appropriate positions.
Press EXIT, then use the
menu item to create the master track.
Press EXIT, and use the menu system to
select either SMF or PATTERN as the MIDI
PLAYER mode, as appropriate.
Press EXIT and press the REC key of at
least one track on which you will be
recording (once a track has been armed in
auto-punch, the track arming status cannot
be changed).
Press EXIT and check the digital audio
source. The 2488 expects a signal in S/PDIF
(IEC60958 Consumer use) format at 44.1kHz.
It cannot accept compressed audio formats,
etc.
Press EXIT and use one of the
operations such as
to free up some space on the partition where
there is not enough space (these operations
cannot be undone).
Press EXIT. Use the
item from the
SONG
deleting the unused song data, this action
will also free up memory, so recording can
continue. Remember that this operation
cannot be undone.
Press YES to change the CD for another
one, or NO to cancel the current operation.
Use a higher-capacity disc when burning a
master track or exporting data, or one of the
same capacity as the current disc when
backing up.
TASCAM 2488 Reference Manual
PRE-MASTERING
menu
SONG
or
DELETE UNUSED ERASE
menu
DELETE UNUSED
menu. As well as
23