Indicators Message - Hitachi CP-S220W User Manual

T T R R O O U U B B L L E E S S H H O O O O T T I I N N G G ( ( c c o o n n t t i i n n u u e e d d ) )

Indicators Message

The POWER indicator, LAMP indicator and TEMP indicator light or blink in the following cases.
Table 1-9. Indicators Message list
POWER LAMP
indicator indicator
Lights
Turns off Turns off Standby status
orange
Blinks
Turns off Turns off Warming up. Wait.
green
Lights
Turns off Turns off Operation status.
green
Blinks
Turns off Turns off Cool down.
orange
Lights Lights
red red
Lights Blinks
red red
Lights
Turns off
red
Lights
Turns off
red
*1) In some cases, when the air holes becomes blocked and the interior temperature rises,
the lamp will be turned off for protection and the LAMP indicator will flash red. In such
cases, turn off the MAIN POWER switch, allow the set to cool (for approx. 20 min.) and
then turn the power on again.
1-20
TEMP
indicator
The lamp does not light.
Wait some time (approx. 20 min.) before turning the
Turns off
power on again. If the indicator still lights, the lamp may
have failed and. Replace with a new lamp.
A lamp has not been inserted or the lamp cover is
missing.
Cut a power source, and happen for about 45 minutes,
and confirm the condition which a ramp and a ramp
Turns off
cover mount this opportunity after cooling it fully. Make
contact with the store when a power source is made ON
again after the modification and it becomes the same
display again.
The cooling fan is not operating.
Cut a power source, and happen for about 20 minutes,
and confirm this opportunity after cooling it whether a
Blinks
foreign substance isn't caught in the fan. Make contact
red
with the store when a power source is made ON again
after the modification and it becomes the same display
again.
Internal overheating. *1)
Confirm this opportunity with the air filter if you don't
become dirty or ambient air temperature doesn't exceed
Lights 35 degrees if intake mouth and an exhaust mouth aren't
red occupied after cooling it cut a power source it happens
for about 20 minutes. Make contact with the store when a
power source is made ON again after the modification
and it becomes the same display again.
Contents