Advertisement
INSTALLATION
Connecting
the Appliance
1. Remove and discard shelf packing clips.
2. Do not install where the room temperature
will go
WAliNIN(7,:
This appliance is designed to operate
below 55 degrees F. It will not run frequently enough
on a nominal 115 volt, 15 amp, 60 cycle line. There
to maintain proper temperature
in the freezer,
should be a separate, grounded circuit serving this
appliance only. Do not use an extension cord.
3. Allow a free flow of"air through the front base grille.
4. For ease nf installation, leave a space of about 1/2
This appliance
is equipped
with a three-pronged
inch between the refrigerator and adjacent walls or
grounding
plug for your protection
against possihle
cabinets. If placed with the hinge side against a wall,
electrical shock hazards. It must he plugged into a
leave additional space so the door can be opened
gr( nnd ng receptacle. Where a standard two-prongwall
w_der. (Refer to the installation
instruetlans
for
receptacle
is
encountered,
it
is
the
personal
more detail.)
responsibility and obligation of the customer to have it
replaced with a properly grounded
three-prong
wall
,5. Level the refrigerator to ensure it sits firmly on the
receptacle.
Do not under any eireumstances,
cut or
floor,
remme the third (ground) prong from the power cord.
To level the refrigerator:
Do not use an adapter plug.
1. Remo_e the base grille.
2. Turn the leveling leg cloekavise to raise the cabinet or
ENERGY
SAVING
TIPS
cmmtercloc_vise
to lower the cabinet.
1. Locate the refrigerator away from heat sources such
as the range, dishwaslmr, heat _ents and direct sun-
light.
2. Keep the freezer filll to near capacity so less cold air
TURN LEG CLOCKWISE
TO
x_dllescape dnring door openings (see page 5).
RAISE
CABINET
CORNER.
TURN
LEG COUNTER-
3.
Let
hot
dishes
cool
sliglitly.
CLOCKWISE
TO LOWER
• V
'
,
CABINET
CORNER.
4.
Co
er
liquids.
5. Clean the refrigerator
condenser coils once a },car,
more often if yon have pets (see page 10).
6. Wipe moisture from the outside of containers before
3. If the floor is not level and it is necessary to raise the
placing them in the refrigerator.
back of the cabinet, roll the back wheels onto a piece
7. Avoid opening the doors too often.
of pl}avood or other shim material.
4. To replace the base grille, center the clips in the cut-
out areas and push in until it snaps into place.
PAGE 1
Advertisement
