Table of Contents
Advertisement
Linksys
VPN Tunnel Backup Idle Time:
If the primary tunnel doesn't work within
configured period, the backup tunnel will be
connected . The default value is 30 seconds .
The router can send DNS requests to one DNS
Split DNS:
server and other DNS requests to another
DNS server . If the address resolution requests
from clients match one of the configured
domain names, it will pass the request to the
assigned DNS server . Otherwise, the request
will be passed to the DNS server assigned to
the WAN port .
DNS1/DNS2: Input the IP address of the DNS
server to use for the specific domains .
Domain Name1~4:
Input the domain names to DNS servers
which the requests for these domains will be
passed to .
Client to Gateway
Go to Configuration > VPN > Client to Gateway to add a new IPSec tunnel .
NOTE Remember to click Save to save your settings before leaving the page .
You can also click Cancel to undo the changes .
NOTE Remember to click Save before leaving the page . You can also click
Cancel to undo the changes .
Add a New Tunnel
You can choose Tunnel to create a tunnel between single remote user and the
router, or choose Group VPN for a group of users .
Tunnel number .
Tunnel No.:
Current VPN tunnel connection name, such as XXX Office .
Tunnel Name:
Give them different names to avoid confusion .
Note: If this tunnel is to be connected to the other VPN
device, some devices require that the tunnel name
is identical to the name of the host end to facilitate
verification .
Interface:
From the drop-down menu, select the WAN port for this
VPN tunnel .
Enable:
Click to enable the VPN tunnel . This option is set to enabled
by default .
Local Group Setup
•
Local Security Gateway Type:
VPN
53
Advertisement
Table of Contents
