Setup > Basic Setup; Language; Network Setup; Wireless > Basic Wireless Settings - Cisco Linksys WUMC710 User Manual

Linksys WUMC710
Setup > Basic Setup
The first screen that appears is the Basic Setup screen Use this screen to change
the browser-based utility's language, or to change the media connector's wired
Ethernet network settings

Language

Language This is used to set the language displayed by the browser-based
utility Select the desired language from the drop-down menu

Network Setup

This section determines if the media connector's IP address is obtained
automatically from a DHCP server, such as your network router (Automatic
Configuration - DHCP), or set manually (Static IP)
Device IP If your network has a DHCP server, such as your network router,
assigning IP addresses to your network devices, then keep the default,
Automatic Configuration - DHCP The media connector will request an
IP address from the DHCP server (usually the network router) If no DHCP
server is found, then the media connector will use its default static IP address,
10.100.1.1, until it detects a DHCP server and is assigned a dynamic IP address
If you want to set a permanent static IP address for the media connector, then
select Static IP
If you select Static IP, then complete the following fields:
Static IP Address Enter a unique IP address that will be used to access the
•
browser-based utility
Subnet Mask
Enter the subnet mask of your wired network
•
Default Gateway Enter the IP address of the default gateway for your
•
network (in most cases, this is your router)
Click Save Settings to apply your changes, or click Cancel Changes to cancel
your changes
Wireless > Basic Wireless Settings
Use the Basic Wireless Settings screen to configure the media connector's basic
wireless and security settings
There are two ways to configure the media connector's settings, manual and
Wi-Fi Protected Setup Wi-Fi Protected Setup is a feature that makes it easy to
set up your wireless network If your network router supports Wi-Fi Protected
Setup and uses WPA or WPA2 security, then you can use Wi-Fi Protected Setup
to automatically connect the media connector
Configuration View
To manually configure your wireless network, select
Manual Refer to Basic Wireless Settings, page 8 To use Wi-Fi Protected
Setup, select Wi-Fi Protected Setup Refer to Wi-Fi Protected Setup, page 9
Advanced Configuration
7