Connecting The Wireless-B Ethernet Bridge For Network Use - Cisco Linksys WET11 Quick Installation Manual

Connecting the Wireless-B
3
Ethernet Bridge for Network Use
A
After configuration, unplug the
power adapter from the
electrical outlet, and unplug
the Ethernet network cable
from the PC.
B
Plug the Ethernet network
cable into the RJ-45 port on
the Ethernet-ready network
device you wish to add to the
wireless network.
C
Plug the power adapter into a
local electrical outlet.
If you do not have an active con-
NOTE:
nection to the Ethernet-ready network
device, then change the position of the
X-II switch.
Congratulations! The installation of
the Wireless-B Ethernet Bridge is
complete.
6
A Division of Cisco Systems, Inc.
For additional information or troubleshooting
help, refer to the User Guide on the Setup CD-
ROM. You can also e-mail for further support.
E-mail Support
United Kingdom and Ireland
support.uk@linksys.com
Latin America
support.la@linksys.com
Website
http://www.linksys.com/international or
http://www.linksys.com/uk
Linksys is a registered trademark or trademark of
Cisco Systems, Inc. and/or its affiliates in the U.S.
and certain other countries. Copyright © 2003
Cisco Systems, Inc. All rights reserved.
WET11-UK_V2-QIG-31013NC JL
®