Setup - Predator Engines 60599 Owner's Manual

Set Up
Read the ENTIRE IMpORTANT SAFETY INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURY:
Operate only with proper spark arrestor installed.
Operation of this equipment may create sparks that
can start fires around dry vegetation.
A spark arrestor may be required.
The operator should contact local fire
agencies for laws or regulations relating
to fire prevention requirements.
Assembly
1. Align Front Support (9) with the holes
on the front of the Hopper (1).
2. Bolt Front Support (9) to Hopper (1) using
Bolts (25) and Flange Nuts (24).
Figure A: Front Support (9) attachment
Page 6
Hopper (1)
Front
Support (9)
Flange Nut (24)
Bolt (25)
For technical questions, please call 1-800-520-0882.
At high altitudes, the engine's carburetor, governor
(if so equipped), and any other parts that control
the fuel‑air ratio will need to be adjusted by a
qualified mechanic to allow efficient high‑altitude
use and to prevent damage to the engine and
any other devices used with this product.
The emission control system for this Engine is
warranted for standards set by the U.S. Environmental
Protection Agency and by the California Air Resources
Board (also known as CARB). For warranty
information, refer to the last pages of this manual.
WARNING! DO NOT INSTALL THIS
ENGINE ON A VEHICLE.
3. Slide a Wheel (10) and Washer (26) onto each
end of the axle on the back of the Hopper.
4. Insert a Cotter Pin (27) through each
end of the axle and bend the Cotter Pin over
to secure the Wheels in place.
axle
Figure B: Wheel (10) attachment
Wheel (10)
Washer (26)
Cotter
pin (27)
ITEM 60599