Troubleshooting - LG NB5530A Owner's Manual

Troubleshooting

PROBLEM
No Power
No sound
No woofer sound
The remote control
does not work
properly.
The Auto power on/
off function does not
work.
When you sense that
outputted sound of
the unit is low.
NB5530A-NB_DGBRLLK_ENG.indd 19
CAUSE & CORRECTION
y The power cord is unplugged.
Plug in the power cord.
y Check the condition by operating other electronic devices.
y Incorrect input source is selected.
Check the input source and select the correct input source.
y The mute function is activated.
Press i or adjust the volume level to cancel the mute function.
y The power cord of woofer is not connected.
Plug the power cord into the wall outlet securely.
y Pairing between the unit and woofer gets disconnected.
Connect the unit and woofer. (Refer to the page 14.)
y The remote control is too far from the unit.
Operate the remote control within about 23 ft (7 m).
y There is an obstacle in the path of the remote control and the unit.
Remove the obstacle.
y The battery in the remote control is exhausted.
Replace the battery with new one.
y Depending on the connected device, this function may not operate.
Check the details below and adjust the unit according to them.
y Switch [ON] state of DRC function to [OFF] by using remote controller.
y With the sound bar connected with TV, change the AUDIO DIGITAL OUT setting
on TV Setup Menu from [PCM] to [AUTO] or [BITSTREAM].
y With the sound bar connected with Player, change the AUDIO DIGITAL OUT
setting on Player Setup Menu from [PCM] to [PRIMARY PASS-THROUGH] or
[BITSTREAM].
y Change Audio DRC setting on Player setup menu to [OFF] state.
Troubleshooting 19
2013-06-20 9:18:08
4