Assembly - NordicTrack NTL79011.4 User Manual

ASSEMBLY

•• Assembly requires two persons.
•• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you  nish all assembly steps.
•• The underside of the walking belt is coated with
high-performance lubricant. After shipping, there
may be some lubricant on top of the walking belt
or on the shipping carton. This is normal. If there
is lubricant on top of the walking belt, wipe it off
with a soft cloth and a mild, non-abrasive cleaner.
•• To identify small parts, see page 6.
1. Make sure that the power cord is unplugged.
Locate the Upright Wire (91) bundled around the
front of the Base (29). Cut the plastic tie securing
the Upright Wire. Route the Upright Wire into the
Base and out of the indicated hole.
See the inset drawing. Cut the plastic tie near
the Upright Wire (91). Be careful not to dam-
age the Upright Wire.
2. Press a Base Cap (87) into each side of the
Base (29).
•• Assembly requires the following tools:
the included hex keys
one adjustable wrench
one Phillips screwdriver
scissors
needlenose pliers
To avoid damaging parts, do not use power tools.
1
29
Cut
Hole
2
87
29
7
Tie
Cut
91
91
87