Hitachi 32HDT55 Operating Manual page 38

Avc (audio video control center) & plasma display monitor
Hide thumbs Also See for 32HDT55:
Table of Contents

Advertisement

Operating the precoded function for your DVD player.
This remote is designed to operate different types of DVD players. You must first program the remote to match the remote command
set of your DVD player (refer to page 41 for pre-codes).
1.
Turn ON your DVD player.
2.
Aim the remote control at the front of your DVD player.
3.
Press and release the DVD button to switch to DVD pre-coded mode.
4.
Hold down the DVD button on the remote and enter the two digit preset code that matches your DVD player, as shown on page 41.
The DVD button light will flash 3 times if the code was accepted.
5.
Aim the remote at the DVD player and press the POWER button. The remote will turn off your DVD player if the correct two digit
preset code is entered. When this occurs, the remote control is programmed for your DVD player. If the DVD player does not turn
off, try a different two digit preset code.
6.
The remote will now control your DVD player.
7.
You will need to set the Display Type of your DVD player to 16:9 Widescreen.
NOTES:
1.
If your DVD player cannot be operated after performing
the above procedures, your DVD player's code has not
been precoded into the remote.
2.
In the unlikely event that your DVD player cannot be
operated after performing the above procedures, please
consult your DVD player operating guide.
3.
The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
DVD Button
This button allows the remote to control your DVD player by
setting it to DVD mode.
PRECODED DVD Buttons
These buttons transmit the chosen precoded DVD codes.
EXCLUSIVE TV Buttons
These buttons are for operating the TV.
NOTE:
Refer to instruction manual of the DVD player for operation of the buttons exclusively for the DVD player.
USING THE REMOTE TO CONTROL DVD FUNCTIONS
TV
DVD
SLEEP
PIP MODE
MY DVD PLAYER CODE IS:
38
POWER
VCR
CBL
STB
SOURCE WIZARD
CD
PVR
AMP
1
2
3
4
5
6
7
8
9
0
INFO
A/V NET
SELECT
VOL
CH
VID 3
PIP
SURF
FREEZE
PIP ACCESS
SWAP
DAY/NIGHT
REC

Advertisement

Table of Contents
loading

This manual is also suitable for:

42hdt5550hdt55

Table of Contents