Restoring All The Recording Settings To Default (Full Auto); Using The Flash - Hitachi DZ-BD10HA Instruction Manual

Select "Camera Functions
2
Setup" "MIC. Filter"
"On"/"Off"
Press the confirmation button
to confirm, then MENU to end.
When the function is turned On,
" " appears in the LCD
monitor (p.31).
• The MIC. filter setting is
retained in memory even when
3
the power is turned off.
• If you set this function to
"On", it is recommended to set
the function to "Off" after
recording before turning off
the power unless you always
intend to use this function.
HDD BD-RE BD-R RAM -RW (VR)
Restoring all the
Recording Settings to
Default (Full Auto)
You can reset the following manually
adjusted recording settings to their
defaults with the press of a single
button.
Function Default
Focus
Exposure
BLC (Backlight)
Program AE
(recording mode)
White Balance
OIS (Optical
Image Stabilizer)
MIC. Filter
Face Detection
52
Setting the recording
settings to full auto
CARD
As shutter speed will slow down
when still photos are recorded in dim
lighting, camera shake may easily
occur. We recommend you use a flash
in this case.
-RW (VF) R CARD
Normally, the flash fires
automatically depending on the
recording conditions (during Auto).
You can also set the flash to On
(always fires) or Off (does not fire).
Flash mode
Auto
The flash fires only when necessary.
See
When the flash is needed, "
Auto p.45
appears in the LCD monitor when you
Auto p.46
press PHOTO halfway, and then the
Off p.47
flash fires when you press PHOTO
Auto p.47
all the way.
Auto p.48
On
On p.50
"
monitor all the time. The flash fires
Off p.51
when you fully press PHOTO.
On p.50
Off
"
monitor and the flash will not fire.
During recording pause or
recording, press FULL AUTO.
"FULL AUTO" appears in the
1
LCD monitor for a while and the
settings are reset to their default
settings.

Using the Flash

" is displayed in the LCD
" is displayed in the LCD
"