Symptom
Disc cover cannot be
Is the disc correctly inserted?
closed.
Remove the disc and then reinsert it.
Connect a fully charged battery or AC adapter/charger,
and then turn the camcorder on and try again.
Operating noise is
This is not a fault. A quiet operating sound is heard as the
heard.
disc rotates during recording or playback, etc.
Some vibrations are
These vibrations or sound are caused by HDD/disc drive.
felt or slight sound is
This does not indicate a fault.
heard from
mechanism.
• No operation can
In the following cases, it will take more time than usual
be performed
until operation is possible:
because the
• Immediately after a disc is inserted.
ACCESS indicator
• When a long time has elapsed since the camcorder was
on this camcorder
remains lit or
• When the temperature is greatly different from the
flashing.
• After a disc or
• When a scratched or dirty disc is inserted.
card is inserted, it
• When the camcorder is subjected to strong vibrations.
takes some time
• When the battery or DC power cord was disconnected
until recording is
possible.
• Is the camcorder connected to a PC with a USB cable?
No image appears on
the LCD screen.
• In playback mode, did the last scene viewed end in a
104
Cause and Correction
turned off last.
status of previous recording.
before turning the power switch off.
Disconnect the USB cable.
wipe to black edit?
Press
.
Reference
page
23
18, 25
—
—
—
68, 81