Serial Port Configuration - Asus A78M-A Manual

Realtek LAN Controller [Enabled]
[Enabled]
[Disabled]
Realtek PXE OPROM [Disabled]
This item appears only when you set the Realtek LAN Controller item to [Enabled] and
allows you to enable or disable the Rom of the Realtek LAN controller. Configuration options:
[Enabled] [Disabled]

Serial Port Configuration

The sub-items in this menu allow you to set the serial port configuration.
Serial Port [Enabled]
Allows you to enable or disable the serial port (COM).Configuration options: [Enabled]
[Disabled]
Change Settings [IO=3F8h; IRQ=4]
This item appears only when you set the Serial Port to [Enabled] and allows you
to select the Serial Port base address. Configuration options: [IO=3F8h; IRQ=4]
[IO=2F8h; IRQ=3] [IO=3E8h; IRQ=4] [IO=2E8h; IRQ=3]
2.6.5 APM
Restore AC Power Loss [Power Off]
[Power On]
[Power Off]
[Last State]
WOL (include AC Power Loss) [Disabled]
[Disabled]
[Enabled]
Power On By PME [Disabled]
[Disabled]
[Enabled]
Power On By Ring [Disabled]
[Disabled]
[Enabled]
2-20
Enables the Realtek LAN controller.
Disables the controller.
The system goes into on state after an AC power loss.
The system goes into off state after an AC power loss.
The system goes into either off or on state, whatever the system state was
before the AC power loss.
Disables Wake On LAN after a power failure (G3 state).
Enables Wake On LAN after a power failure (G3 state).
Disables the PME to wake up by PCI/PCIE devices.
Allows you to turn on the system through a PCI/PCIE LAN or modem card.
This feature requires an ATX power supply that provides at least 1A on the
+5VSB lead.
Disables Ring to generate a wake event.
Enables Ring to generate a wake event.
Chapter 2: BIOS information