Table 4.12 Results Of Pairmon Command Options - Hitachi TAGMASTORE MK-90RD011-25 User Manual

Output of the pairmon command:
Group: This column shows the group name (dev_group) which is described in the
configuration definition file.
Pair vol: This column shows the paired volume name (dev_name) in the specified group
which is described in the configuration definition file.
Port targ# lun#: These columns show the port ID, TID, and LUN which is described in
the configuration definition file. For further information on fibre-to-SCSI address
conversion, see Appendix C.
LDEV#: This column shows the LDEV ID for the specified device.
Oldstat: This column shows the old pair status when the status of the volume is
changed.
Newstat: This column shows the new pair status when the status of the volume is
changed.
code: This column shows the storage system-internal code for the specified status.
Table 4.12 Results of Pairmon Command Options
-D -nowait -resevt
-D
Invalid
Invalid -resevt
Invalid -resevt
Invalid -nowait
Invalid -nowait
Invalid -nowait -resevt
Invalid -nowait -resevt
-allsnd Actions
When HORCM does not have an event, this option waits until an event occurs. If one
or more events exist, then it reports one event and resets the event which it reported.
-allsnd When HORCM does not have an event, this option waits until an event occurs. If one
or more events exist, then it reports all events.
When HORCM does not have an event, this option waits until an event occurs. If one
or more events exist, then it reports one event and resets all events.
-allsnd When HORCM does not have an event, this option waits until an event occurs. If one
or more events exist, then it reports all events and resets all events.
When HORCM does not have an event, this option reports event nothing. If one or
more events exist, then it reports one event and resets the event which it reported.
-allsnd When HORCM does not have an event, this option reports event nothing. If one or
more events exist, then it reports all events.
When HORCM does not have an event, this option reports event nothing. If one or
more events exist, then it reports one event and resets all events.
-allsnd When HORCM does not have an event, this option reports event nothing. If one or
more events exist, then it reports all events and resets all events.
Hitachi Command Control Interface (CCI) User and Reference Guide 193