Cci Pair Command Results; Troubleshooting With Command Control Interface - Hitachi VSP G1000 User Manual

CCI pair command results

To avoid getting mixed results, run CCI commands on pairs that are in the
required status.
The following table shows the results of running commands on pairs
depending on their status.
Status
SMPL
COPY
PAIR/PFUL Np
PSUS/
PFUS
RCPY
PSUE
*Terminates normally, regardless of the pair status, when the snapshot tree is specified as the
range to be deleted.
Legend:
Ok: The command ends normally and the task is performed.
Np: The command is not rejected and ends normally but the task is not performed.
Ab: The command is rejected and ends abnormally.
Do not specify noread mode (-m noread) for S-VOLs using CCI. If you do, the
command ends normally but the noread mode does not take effect.
If a CCI command is rejected and ends abnormally and the host is running
the HP-UX operating system, sense bytes (SSB) are output to the CCI error
log file. Sense bytes indicate the cause of the error.
For more information about SSB and error causes, see
Command Control Interface on page

Troubleshooting with Command Control Interface

To identify the cause of errors that occur when you run CCI commands, refer
to the log displayed in the CCI window or the CCI operation log file.
Procedure
1. Find the error code in the log displayed in the CCI window or the CCI
operation log file. The CCI log file's default location is /HORCM/log*/
Hitachi Thin Image User Guide for Hitachi Virtual Storage Platform G Series and F Series
paircreat paircreat
e e -split
Ok Ab Ab
Np Ab Ab
Ok Ok
Ab Np Np
Np Ab Ab
Ab Ab Ab
CCI command reference for Thin Image
CCI command
pairresyn pairresyn
pairsplit
c c -restore
Ab Ab
Np Np
Np Np
Ok Ok
Np Np
Ok Ab
213.
pairsplit - pairsplit -
S* E
Np Ab
Ab Ab
Ok Ab
Ok Ab
Ab Ab
Ok Ab
Troubleshooting with
213