Using Memory - Hitachi VM-H57A Instruction Manual

Getting Started

Using Memory

The linear time counter memory stops a rewinding tape at approximately 0:00:00M. This
feature helps in locating a specific point in the tape to which you wish to return. An
example might be that you have recorded some tape that you have already watched,
you continue recording but do not care to watch the tape you recorded earlier. The
memory feature returns you to the beginning of the most recent recording.
1. Press the DISPLAY button on the remote control so the linear time counter with
memory is displayed as shown in the figure.
2. Start recording or playback of a cassette. Press the COUNTER RESET button on the
remote control at the point to which you wish to return. The linear time counter clears to
0:00:00M.
3. Continue recording or playback until ready to return. Press STOP when finished.
4. Press the REW/REVIEW button and the tape stops at approximately where you reset
the linear time counter. This feature works in F.FWD as well.