Beep Codes - Dell Dimension 5150 Service Manual

compatibility error exists.
A possible expansion card failure
has occurred.
Another failure has occurred.
The computer is in a normal
operating condition after POST.
NOTE:
not lit after the system
successfully boots to the
operating system.

Beep Codes

Your computer might emit a series of beeps during start-up if the monitor cannot display errors or problems. This series of
beeps, called a beep code, identifies a problem. One possible beep code (code 1-3-1) consists of one beep, a burst of three
beeps, and then one beep. This beep code tells you that the computer encountered a memory problem.
If your computer beeps during start-up:
1. Write down the beep code.
2. Run the Dell Diagnostics
3. Contact Dell for technical assistance (see your computer Owner's Manual for information about how to contact Dell).
Back to Contents Page
The diagnostic lights are
to identify a more serious cause.
Verify that the memory modules that you are installing are
compatible with your computer (see "Memory").
If the problem persists, contact Dell (see your computer
Owner's Manual for information about how to contact Dell).
1. Determine if a conflict exists by removing a card (not a
graphics card) (see "Cards")and restarting the computer.
2. If the problem persists, reinstall the card that you removed,
remove a different card, and then restart the computer.
3. Repeat this process for each card. If the computer starts
normally, troubleshoot the last card removed from the
computer for resource conflicts (see "Resolving Software and
Hardware Compatibilities" in your computer Owner's Manual).
4. If the problem persists, contact Dell (see your computer
Owner's Manual for information about how to contact Dell).
Ensure that the cables are properly connected to the system
board from the hard drive, CD drive, and DVD drive (see
"System Board Components").
If there is an error message on your screen identifying a
problem with a device (such as the floppy drive or hard drive),
check the device to ensure that it is functioning properly.
The operating system is attempting to boot from a device (such
as the floppy drive or hard drive); check
ensure that the boot sequence is correct for the devices
installed on your computer.
Check the computer message that appears on your monitor
screen.
If the problem persists, contact Dell (see your computer
Owner's Manual for information about how to contact Dell).
None.
system setup to