Advertisement
Quick Links
MA1202-EA
Your watch may differ somewhat from the one shown in the illustration.
Before Using the Watch for the First Time
Depending on your watch model, there may be a spacer installed
at the factory around the crown. If your watch has a spacer, you
should remove the spacer before using the watch.
After removing the spacer, use the procedures in "Crown
Operations" and "To adjust the time setting" to set up the watch
for use.
To adjust the time setting
When the second hand is at 12 o'clock, pull
the
out to Click 2.
Crown
Rotate the
Crown
to change the time setting.
Push the
back in.
Crown
To change the day and day of the week settings
Pull the
out to Click 1.
Crown
Rotate the
towards you to set the day.
Crown
Rotate the
away from you to set the
Crown
day of the week.
Push the
Crown
back in.
Crown Operations
Some water-resistant models (100 meters, 200 meters)
have a screw-in crown. When you need to perform a crown
operation, rotate it towards you to unscrew it. Then pull the
crown out. Avoid applying undue force when pulling. The watch
loses its water resistance while the crown is unscrewed. After
performing a crown operation, fully screw the crown back in.
If your watch has a rotary bezel...
You can rotate the bezel to align its ▼ mark with the
minute hand. Then you will be able to tell how much
time has elapsed since aligning the ▼ mark.
Specifi cations
Accuracy: ±20 seconds average per month
Other: Low battery alert
Power Supply: Solar panel and one rechargeable battery
Approximate battery operating time: 8 months
Operation Guide 5272
Spacer
Crown
Click 2
Click 1
Crown
Note
When changing the time,
move the minute hand four
or fi ve minutes past your
fi nal setting, and then back it
up to the setting you want.
Note
The day setting uses a
31-day month. Make
adjustments for months of
shorter lengths.
Avoid changing the day and
day of the week settings
between the hours of 9 p.m.
and 4 a.m. Otherwise, the
day and day of the week
may not change correctly at
midnight.
Crown
Loosen
Start
Elapsed time
Current
Solar Charging
A solar panel generates electrical power that charges a built-in (secondary) battery.
The entire face is a solar panel, so power is generated when the face is exposed to
light. Keep the watch exposed to light as much as possible.
Charging the Battery
When you are not wearing the watch, leave it where it is exposed
to light. For stable operation, expose the watch to at least a half
day of light per month.
When wearing the watch, try to keep your clothing from blocking
its face (solar panel). Charging effi ciency is reduced signifi cantly
even if the face is blocked only partially.
Caution!
The case of the watch may become quite hot when charging. Guard against burn
injury after charging.
Avoid charging in the following locations, and anywhere else where the watch may
become very hot.
−
On the dashboard of an automobile parked in the sun
−
Close to an incandescent light source or other sources of heat
−
Locations exposed to direct sunlight for long periods
Low Charge and Dead Battery Conditions
An alert operation is performed when the battery charge goes low.
Low Battery Alert
The second hand will jump at two-second intervals to alert you when the charge is
low.
Regular Timekeeping
Low charge
Charged
Charging Time
The times below are general guidelines for reference only.
Charging Time to Support Daily Use
Exposure Level (Brightness)
Outdoor sunlight (50,000 lux)
Sunlight through a window (10,000 lux)
Daylight through a window on an overcast day
(5,000 lux)
Indoor fl uorescent lighting (500 lux)
Charging Time to Recover from Dead Battery
Approximate
Charging Time to
Exposure Level (Brightness)
1-second Hand
Movement
Outdoor sunlight (50,000 lux)
Sunlight through a window (10,000 lux)
Daylight through a window on an
overcast day (5,000 lux)
Indoor fl uorescent lighting (500 lux)
Important!
The watch will continue to run for about eight months after a full charge, even if it is
not exposed to light. For stable operation, however, expose it to light as much as
possible.
Note
Actual charging time depends on environmental conditions.
Over-charge Protection
Charging stops automatically when a full charge is attained. This protects against
over-charging.
Low Battery Alert
2-second jump
Approximate Charging Time
8 minutes
30 minutes
48 minutes
8 hours
Approximate Time
to Full Charge
5 hours
43 hours
18 hours
160 hours
28 hours
256 hours
277 hours
– – –
1
Advertisement
