List Of Memory Switch Settings - Brother Z-8550A Service Manual

3-2. List of memory switch settings

Memory switch No. 0 - 15
No. Initial value
0 0 (degrees)
1 0 (degrees)
2 0
3 1
4 0
5 0
6 0
7 0
9 0
12 0
13 0
14 0
15 0
Setting range
Needle up stop position setting
-10 - 10
(degrees)
Higher
Needle down stop position setting
-10 - 10
(degrees)
Higher
Depressing treadle forward when treadle is depressed backward (thread
trimming)
0 - 1
0: Disabled (Enabled after treadle is returned to neutral position and then
depressed forward)
1: Enabled
Power supply voltage drop check (reset detection) function
0 - 1
0: None
1: Enabled, [Err 95] displayed when voltage drops.
Buzzer (electronic sound) during panel operation
0 - 1
0: Yes
1: None
-
[Do not change this setting.]
Piercing force boosting operation
0 - 1
0: Yes
1: None
End backtacking speed
0 - 1
0: Limited by speed bar key setting
1: Not limited by speed bar key setting
End backtacking sewing speed
0 - 1
0: Speed can be set independently from start backtacking speed
1: Speed is set to start backtacking speed
Presser foot condition when treadle is returned to neutral position after
thread trimming
0 - 1
0: Presser foot is lowered (it is not lowered when DIP switch 1 is OFF)
1: Presser foot is not lowered
Presser foot condition when operation stops at the neutral treadle position
0 - 1
0: Presser foot is not lifted
1: Presser foot is lifted
Actuator function
0: Operates as a reverse stitch switch during sewing, and as a correction
0 - 1
stitch switch when sewing is stopped
1: Thread trimming switch
Deceleration stop control when treadle is returned to neutral position
0 - 1
0: Deceleration stop control without single stitch advance
1: Above control is not carried out
Z-8550A, 8560A
3. FUNCTION SETTINGS
Setting details
Lower
0212B
Lower
0212B
4