Creating A Title; Correcting Errors; Recording Title On A Tape In The Camcorder - Hitachi VM-E230A Instruction Manual

Advanced Techniques

Creating a Title

1. Connect the camcorder to a power source.
2. Hold down the red button on the CAM/OFF/VIDEO switch and slide it to either CAM
or VIDEO.
3. Press the TITLE ON/OFF button on the remote control and a flashing cursor appears
in the viewfinder.
4. Use the STOP button to place the cursor where you wish to begin your title.
5. Use the F.FWD and REW buttons to select the first character of your title.
6. Once you've selected a character press the STOP button to set it.
7. Complete the title by repeating steps 5 and 6.
8. When you complete your title, press the TITLE ON/OFF button on the remote control
to store the title in memory and remove the title graphics from the viewfinder.
Note: As long as the correct current time can be displayed, the title is held in memory.

Correcting Errors

1. Press the TITLE ON/OFF button on the remote control.
2. Use the STOP button to select the character to be corrected.
3. Use the F.FWD or the F.F (on the camcorder) and REW buttons to correct the
character.
4. Press the TITLE ON/OFF button on the remote control to store the corrected title in
memory.

Recording Title on a Tape in the Camcorder

1. Hold down the red button on the CAM/OFF/VIDEO switch while sliding the switch to
CAM.
2. Locate the point of the tape where you wish to record the title ("Using Quick Edit,"
p.36).
3. Press the TITLE ON/OFF button on the remote control.
4. Press the Start/Stop button to start recording the title.