VIEWFINDER BRIGHT CONTROL
VIEWFINDER BRIGHT CONTROL
Viewfinder brightness can be adjusted by turning the "BRIGHT" control. This does not affect the picture actually
recorded by the camcorder.
HOW TO ATTACH THE SHOULDER STRAP
Attach the shoulder strap (provided), as illustrated.
TROUBLESHOOTING
Your camcorder is a highly sophisticated instrument. It has been carefully checked and adjusted at the factory
under the most rigid quality control and inspection systems. However, should problems develop, check the
following points and take necessary corrective measures.
INSERTING OR REMOVING THE CASSETTE
Symptom
Cassette holder cannot be opened when you press
"STOP/EJECT".
Cassette cannot be inserted into cassette compartment.
CAMERA RECORDING
Symptom
Picture does not appear in the viewfinder. * Remove the lens cap.
The camcorder can not go into the
recording mode, even when
"REC/PAUSE" is pressed.
Picture is out of focus.
Auto-focus does not operate.
BATTERY CONDITION
Check Point & Correction
* Connect the power source.
* Load cassette in direction indicated by arrow on
cassette.
* Cassette window must be toward outside.
Check Point & Correction
* Set "CAM/OFF/VIDEO" to "CAM" position.
* The cassette has had the erase prevention tab removed. Stick a
piece of cellophane tape over the erase prevention hole or select a
different cassette.
* Set "CAM/OFF/VIDEO" to "CAM" position.
Auto-focus does not operate if the wide angle or telephoto lens is
attached.
- 35 -