Program Ae (Auto Exposure); Power Zoom; Digital Zoom - Hitachi VM-7400A Instruction Manual

DIGITAL ZOOM

- 25 -
viewfinder.
• With some tapes, "TAPE END" may appear slightly earlier, but you can continue recording.

PROGRAM AE (Auto Exposure)

Program AE automatically selects the shutter speed 1/60,1/100,1/120,1/180, 1/250, 1/350,1/500, l/750, 1/1000,
1/1500, 1/2000 or 1/4000 second that is optimum for the brightness of the subject. The iris is also adjusted
automatically in response to the shutter speed.

POWER ZOOM

• Press the power zoom switch on the "W" side, and the picture gradually widens.
• Press the power zoom switch on the "T" side, and the picture gradually becomes telescopic.
When "DISPLAY" is pressed so the display appears in the viewfinder and the power zoom switch is pressed,
the zoom position is displayed in the viewfinder in 10 steps for several seconds.
DIGITAL ZOOM
The digital zoom increases the magnification of the power zoom by 4.5 times. You must place the subject you
wish to magnify at the center of the viewfinder.
Press and hold the power zoom T control until you find the picture you want. You control the zoom with the
power zoom T and W controls. When "DISPLAY" is pressed and the display appears in the viewfinder,
"ZOOM" is displayed to signal to you that the camcorder is in the digital zoom area.