Table of Contents
Advertisement
TROUBLESHOOTING
If you are having trouble with the TV card, check the following items to see if the
problem can be resolved. Sometimes another device may be at fault, so be sure to also
inspect the other devices being used. If the trouble cannot be resolved, contact your
nearest PIONEER authorised service centre or your supplying dealer.
Problem
Cannot switch to inputs 3-5
Remote control unit does not operate
No Pictures
Unit cannot be operated
Picture is cut off
Green Pictures
An outline of previous still images
can be seen on the screen even
when a different input is selected
ADDITIONAL INFORMATION
Possible Solution
TV card is not inserted correctly, ensure card is
correctly inserted .
Are batteries inserted with correct polarity.
Are batteries worn out (Replace with new
batteries)
Are you using it under strong fluorescent
lighting?
Is a fluorescent light illuminating the remote
control sensor?
Is connection to other components correct? (See
pages 8-11)
Has set-up been done correctly after connection?
(see page 27)
Is the correct input selected?
Is a non-compatible signal being connected?
Is picture adjustment correct? (See pages 20-21)
Please remove the TV Card from the Plasma,
if normal operation and picture on inputs 1 and 2
are restored the TV Card has a malfunction.
External influences such as lightning, static
electricity ,etc, may cause improper operation.
In this case turn off the power for 1-2 minutes
and try again.
Please remove the TV Card from the Plasma,
if normal operation and picture on inputs 1 and 2
are restored the TV Card has a malfunction.
Are settings for picture format correctly set.
(See page13)
Ensure Slot interface setting is set to
COMPONENT1(refer to page7 'setting integrator
menu')
After displaying a PC image or any other still
image, it is recommended to view a normal moving
picture in the 'Wide' or 'Full' screen setting for more
than 3 times the length of the previous still image.
29
Advertisement
Table of Contents
