Table of Contents
Advertisement
A D V A N C E D
O P E R A T I O N S
The following output resolutions are available:
PAL output via HDMI 1 or HDMI 2:
NTSC output via HDMI 1 or HDMI 2:
PAL output via Analog (component):
NTSC output via Analog (component):
* When 1080p is selected for the Analog output, the actual component output resolution will be 1080i.
NOTE
Some TV sets do not support one or more output resolutions (particularly 1080p). If
an incompatible output resolution is selected, you will get a blank screen or an error
message. In this case please select an output resolution that is supported by the TV.
In case you are not able to get a picture using the HDMI or component output, please
connect the player to the TV using the composite video output, then use the Setup
Menu to adjust the player settings.
Video up-conversion over the component output is only available for unencrypted
discs such as home video and consumer-created contents.
pressed DVD discs are CSS-encrypted and will be limited to 576i/576p resolution.
This restriction applies to the component output only. The HDMI output is protected
with HDCP and has no such restriction.
Zooming and Aspect Ratio Control
ZOOM
Zoom Levels for HDMI 1 Output
The following zoom levels are available when "Primary Output" is set to "HDMI 1":
Under Scan
The zoom level is reset to 1:1 when the disc is ejected, or when the player is turned off.
Auto
1080p(50Hz/24Hz)
576p
Auto
1080p(60Hz/24Hz)
480p
1080p 50Hz*
1080i 50Hz
1080p 60Hz*
1080i 60Hz
This feature zooms in or out of the displayed frame and also changes the
aspect ratio (image width vs. height).
To change the zoom level, press the ZOOM button on the remote control.
Each press of the ZOOM button will switch the zoom level in sequence.
1:1 (No zooming)
1.2
1.3
1080i 50Hz
576i
Source Direct
1080i 60Hz
480i
Source Direct
720p 50Hz
720p 60Hz
Stretch/Compress
Full Screen
1.5
2.0
½
Back to 1:1 again
34
720p 50Hz
720p 60Hz
576p
576i
480p
480i
Most commercially
DVD-A
Advertisement
Table of Contents
