Signaling Operations; Call Procedure - Icom IC-F3011 Instruction Manual

4
NOTE: The tone signalling operations are available for the
IC-F3013/F4013 only.

■ Call procedure

When your system employs tone signalling (excluding CTCSS and
DTCS), the call procedure may be necessary prior to voice trans-
mission. The tone signalling employed may be a selective calling
system which allows you to call specific station(s) only and prevent
unwanted stations from contacting you.
q Select the desired TX code channel or 2/5-tone code according
to your System Operator's instructions.
• This may not be necessary depending on programming.
w Push [Call]. (p. 11)
e After transmitting a 2/5-tone code, the remainder of your com-
munication can be carried out in the normal fashion.
Selective calling
D Transmitting notes— PTTID call
The transceiver sends the ID code (5-tone, DTMF or digital ANI)
automatically when [PTT] is pushed (beginning of transmission)
and released (end of transmission) depends on the setting.
16

SIGNALING OPERATIONS

Non-selective calling