Icom IC-FR3000 Remote Control Manual page 10

1
REMOTE CONTROL OPERATION
OPERATION EXAMPLE (Continue)
D D Master Enable
This command is available from both the transceiv-
er and phone line. This explanation shows the step
by step operation from the transceiver or operation
from the phone line when entering the password and
command continuously (one after the other).
[From the Transceiver]
q Enter the programmed password from the trans-
ceiver.
Code: ∗ 0001#
• Verify the repeater replies "System Password OK
ACK (1111)."
• If the repeater replies "NG ACK (4040)," make sure
the password, header tone and de-limiter tone are
correct, and try again.
w Enter the "Master Enable" command within 10
sec.
Code: ∗ 0013#
• Verify the repeater replies "OK ACK (3333)."
• If the 10 sec. input standby time runs out, enter the
password and command continuously (Code:
∗ 0001#0013#
).
• The operating repeater switches to the Master
repeater.
[From the Phone line]
q Dial the phone number of the phone line that the
repeater is connected to.
w When the connection has been confirmed, enter
the following DTMF code.
Code: ∗ 0001#0013#
• Verify the repeater replies "OK ACK (3333)."
• If the repeater replies "NG ACK (4040)," make sure
the password, header tone, de-limiter tone and
Master Enable code are correct, and try again.
• The operating repeater switches to the Master
repeater.
e Hang up the phone, the repeater automatically
disconnects the phone.
9
(0013 Default)
D D Slave Enable (0014 Default)
This command is available from the transceiver and
phone line. This explanation shows the operation
from the transceiver when entering the password
and command continuously or step by step operation
from the phone line (one after the other).
[From the Transceiver]
➥ Enter the following DTMF code from transceiver.
Code: ∗ 0001#0014#
• Verify the repeater replies "OK ACK (3333)."
• If the repeater replies "NG ACK (4040)," make sure
the password, header tone, de-limiter tone and Slave
Enable code are correct, and try again.
• The operating repeater switches to the Slave
repeater.
[From the Phone line]
q Dial the phone number of the phone line that the
repeater is connected to.
w When the connection has been confirmed, enter
the programmed password.
Code: ∗ 0001#
• Verify the repeater replies "System Password OK
ACK (1111)."
• If the repeater replies "NG ACK (4040)," make sure
the password, header tone and de-limiter tone are
correct, and try again.
e Enter the "Slave Enable" command within 10 sec.
Code: ∗ 0014#
• Verify the repeater replies "OK ACK (3333)."
• If the 10 sec. input standby time runs out, enter the
password and command continuously (Code:
∗ 0001#0014#
).
• The operating repeater switches to the Slave
repeater.
r Hang up the phone, the repeater automatically
disconnects the phone.