Table of Contents
Advertisement
Rear Panel View
GB
1
2
3
1. Video (DISC) Output
2. Audio (DISC) Output
3. SW Aerial Connector Terminals (Option)
4. Voltage Selector(Option)
5. Loudspeaker Connector Terminals
6. AUX-Input
7. AM Aerial Connector Terminals
8. FM Aerial Connector Terminal
Where to Install Your Mini-Compact System
To take full advantage of your new mini-compact system, follow
these installation instructions before connecting the unit.
Install the system on a flat, stable surface.
Never place this unit on carpeting.
Never place this unit in an outdoor area.
Maintain an open space of approximately 6 inches (15 cm) on the
sides and rear of the system, for ventilation purposes.
Make sure that you have enough room to open the compact disc
compartment easily.
Place the loudspeakers at a reasonable distance on either side of
the system to ensure good stereo sound.
Direct the loudspeakers towards the listening area.
For optimum performance, make sure that both speakers are placed
at an equal distance above the floor.
6
8
7
6
5
4
Connecting your System to the
Power Supply
Before plugging your system into a main socket, you must check
the voltage.
1
Check the position of the voltage selector on the rear of the system
(OPTIONAL).
2
Plug the main lead into an appropriate socket.
3
Press the Standby/ON button to switch your mini-compact system .
Inserting Remote Control Batteries
Insert or replace remote control batteries when you:
Purchase the mini-compact system
Find that the remote control is no longer operating correctly
When replacing the batteries, use a new set of batteries and
never mix alkaline and manganese batteries.
1
Place your thumb on the position marked
on the battery
compartment cover (rear of the remote control) and push the cover in
the direction of the arrow.
2
Insert two AAA, LR03 or equivalent batteries, taking care to respect
the polarities:
+ on the battery against + in the battery compartment
– on the battery against – in the battery compartment
3
Replace the cover by sliding it back until it clicks into position.
If you will not be using the remote control for a long time,
remove the batteries to prevent corrosion.
Connecting to an External Source
The auxiliary input can be used to take advantage of the
sound quality of your mini-compact system when listening to
other sources.
Examples:
A television
A video disc player
A Hi-Fi stereo video cassette recorder
To connect to the external source, the source must have an
audio output. In addition, you need an RCA connection cable.
1
Set the system to standby mode and disconnect it and the external
source from the main socket.
2
Connect the audio cable to the rear of the mini-compact system.
Connect the...
To the connector marked...
Red jack
R (right)
White jack
L (left)
For optimum sound quality, do not invert the right and left
channels.
3
Plug the system back into the main socket and press
STANDBY/ON to switch it on.
4
Select the AUX source by pressing AUX.
Result: AUX is displayed.
5
Switch the external source on.
6
Adjust the volume and balance as required:
Volume
Equalizer
Example: You can watch a film and take advantage of stereo sound
provided that the original sound track is in stereo (as if you
were in a cinema).
3
4
GB
7
Hide quick links:
Advertisement
Table of Contents
