Enhancing Your System - Sharp GX-CD1300MP MK2 Operation Manual

Enhancing your system

GX-CD1300MP
MK2
ENGLISH
FUNCTION
MIX MIC
RECORD
Mixing from a microphone and TAPE
■
To listen to or record mixed signals from an external microphone and
TAPE 2.
1
To protect the speakers from shock noise and to avoid
disturbing noises, set the VOLUME control to minimum.
●
Be sure that the microphone has a 3.5 mm (1/8") diameter
plug, and is of 600 ohms impedance: if not, use an
appropriate adaptor.
2
Connect the microphone plug to the MIX MIC socket.
3
Set the FUNCTION switch to TAPE.
4
Set the DUBBING SPEED switch to NORMAL.
●
Mixing recording is not possible if the DUBBING SPEED
switch is set to HIGH or MIC.
E-31
/
DUBBING
VOLUME
SPEED
.
.
PLAY
5
Load a blank tape into the TAPE 1 cassette compartment
for recording or insert a pre-recorded cassette into the
TAPE 2 cassette compartment.
6
Adjust the volume of the audio source and the microphone
using the VOLUME control.
7
For mixing playback, press the PLAY button of TAPE 2. For
mixing recording, press the PLAY button of TAPE 2 and
RECORD button of TAPE 1.
Notes:
●
Place the microphone about 10 - 15 cm (4 - 6") away from the
source.
●
If howling occurs, lower the volume or move the microphone as far
as possible from the speaker.
●
To record the microphone signals only, load a cassette into the
TAPE 1 cassette compartment, set the FUNCTION switch to
TAPE and the DUBBING SPEED switch to NORMAL. Then, press
the RECORD button.
Caution:
When not using the microphone, remove the microphone plug from
the MIX MIC socket.