Troubleshooting - Fellowes POWERSHRED 79Ci Quick Manual

PRODUCT MAINTENANCE
OILING SHREDDER
All cross-cut shredders require oil for peak performance. If not oiled, a
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
Press and hold forward
*Apply oil across entry
( ) 2-3 seconds
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250

TROUBLESHOOTING

A B C
JAM PROOF SYSTEM*
Eliminates paper jams and powers through tough jobs.
DISABLING THE FEATURE
2
1
Should you choose to disable Once disabled, the blue
the system, press and hold Auto light is no longer
the auto button (blue) and illuminated (To re-engage,
reverse ( ) key at the repeat step 1)
same time
*100% Jam Proof when used in accordance with user manual
15
D E
3
AUTO AUTO
Shredding can continue with
the system disabled, however a
paper jam may occur with too
many sheets and Remove
Paper icon ( ) will illuminate
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors
may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1
2
Turn off and unplug Locate Auto-start
shredder infared sensor
A. Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum
operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will
not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
the continuous operation and recovery time for this shredder.
B. Bin Open: The shredder will not run if the bin is open.
When illuminated, close the bin to resume shredding.
C. Bin Full: When illuminated, the shredder waste bin is full and needs to be emptied.
Use Fellowes waste bag 36052.
D. Remove Paper: When illuminated, press reverse (
Reduce paper quantity to an acceptable amount and refeed into paper entry.
E. SafeSense Indicator: If hands are too close to the paper entry, the SafeSense
®
and the shredder will stop shredding. If SafeSense
turn off and the user must press the power button on the control panel to resume shredding.
5 3 4
If jam occurs, press and
hold forward ( ) key until
the document is completely
through the shredder
.
4
3
Dip cotton swab in Using cotton swab, wipe
rubbing alcohol away any contamination
from the paper sensors
) and remove paper.
indicator will illuminate
®
is active for 3 seconds, the shredder will automatically
®
3 5
5
6
If not cleared, press If steps 4 and 5 do not clear
reverse ( ) briefly jam, reverse paper all the
(repeat steps 4 and 5 way out, remove several
until shredded) sheets and refeed
ENGLISH
Model 79Ci
4