Setting The Clock; Loading And Changing Compact Discs - Samsung MAX-N75 Instruction Manual

Setting the Clock

GB
Your system is equipped with a clock which allows you to
turn your system on and off automatically. You should set the
clock:
When you purchase the mini-compact system
After a power failure
After unplugging the unit
Remember to reset the time when the clock changes from
winter to summer time and vice versa.
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
1
Switch the system on by pressing On/Standby.
2
Press Timer/Clock twice.
Result: CLOCK is displayed.
3
Press Manual EQ/Enter.
Result: The hour flashes.
4
To...
Increase the hours
Decrease the hours
5
When the correct hour is displayed, press Manual EQ/Enter.
Result: The minutes flash.
6
To...
Increase the minutes
Decrease the minutes
7
When the correct time is displayed, press Manual EQ/Enter.
Result: The clock starts and is displayed, even when the system is in
standby mode.
You can display the time, even when you are using another function,
by pressing Timer/Clock once.
On/Standby
Game
Demo
1
Aux
PTY
RDS
Display
Timer/
Clock
Band
2
TUNER
Rev Mode
Dubbing
Normal
CD REC/Pause
10
Turn the Moving Jog knob to the...
Right
Left
Turn the Moving Jog knob to the...
Right
Left
3,5,7
CD
4,6
Moving Control Manual EQ /Enter
Deck 1/2 Mono/ST
Counter Reset Preset/Memory
REC/Pause
Preset/Manual
High
Loading and Changing Compact
Discs
The CD disc changer can contain up to three 12 cm or 8 cm
compact discs without using an adapter.
Never force the compact disc carrousel when opening and clos-
ing the compartment.
Never press down or place objects on the carrousel.
Always treat your compact discs with care; refer, if necessary, to
the section entitled "Precautions When Using Compact Discs" on
page 25.
1
Switch the system on by pressing On/Standby.
2
Press the Open/Close button on the front panel.
Result: The compartment opens.
3
Place one or two discs in the front slots of the carrousel, with the label
on the discs facing upwards.
Check that the compact disc has been correctly inserted in
the holder before closing the compartment.
4
If you wish to load a third compact disc, press the Disc Change but-
ton on the front panel (or Disc Skip on the remote control).
Result: The carrousel rotates by 120°.
5
Close the compartment by pressing the Open/Close button again.
If you wish to start playing a disc directly, you can also
proceed as follows.
To play...
Disc 1
Disc 2
Disc 3
Result: The compartment closes automatically and the disc selected
6
To change or unload the compact disc changer, repeat Steps 2 to 5.
Keep the compartment closed whenever you are not using it,
to prevent dust from entering.
Volu
+
You can load or unload compact discs when the radio,
tape or auxiliary source function is selected.
–
TAPE
On/Standby
Program
CD Repeat
1
Aux
Shuffle CD Synchro
starts playing.
Disc 1 Disc 1 Disc 2 Disc 2 Disc 3 Disc 3
5
Game
Demo
PTY
RDS
Display
5
Timer/
Clock
Band
TUNER CD CD
Moving Control Manual EQ /Enter
Press...
CD ( ) or Disc 1
Disc 2
Disc 3
Disc Change
Open/
Open/
Close
Close
2,5
4
Volume
+
–
ower
Surround
TAPE