Installation - Electralog Compact Owner's Manual

Installation

!
NOTE: A 15 Amp, 120 Volt
alternating current (VAC) circuit
is required. A dedicated circuit
is preferred but not essential in
all cases. A dedicated circuit will
be required if, after installation,
the circuit breaker trips or fuse
blows on a regular basis when the
heater is operating. Additional
appliances on the same circuit
may exceed the current rating of
the circuit breaker.
WARNINg: Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk
of fire, electric shock or injury to
persons.
Figure 1
Hardware
Main Body
Rear support
Mantel top
WARNINg: Construction
and electrical outlet wiring must
comply with local building codes
and other applicable regulations
to reduce the risk of fire, electric
shock and injury to persons.
WARNINg: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.
(No assembly required for the
flat wall mantel)
Corner Mantel Assembly
1. assemble the top of the
mantel to the rear support
using the supplied hardware.
2. using the supplied hardware
assemble the top and rear
support assembly to the main
fireplace body (Figure 1).
Fireplace Installation
1. Make sure the unit's Main
ON/OFF switch is switched
OFF (refer to operating
instruction section).
2. Plug the unit into a 15 Amp,
120 VAC outlet. If the cord
does not reach, you may use
a No. 14 AWG minimum size
extension cord rated for a
minimum of 1875 Watts.
7