La Crosse Technology WS-9711U-IT Instruction Manual page 10

Wireless 915 mhz temperature station
Table of Contents

Advertisement

If the Weather Station is moved to another location significantly higher or lower than its initial
standing point (for example from the ground floor to the upper floors of a house), remove the
batteries and re-insert them after about 30 seconds. By doing this, the Weather Station will
not mistake the new location as being a possible change in air-pressure when really it is due
to the slight change of altitude. Again, disregard weather forecasts for the next 48-60 hours
as this will allow time for operation at a constant altitude.
THE WEATHER TENDENCY INDICATOR
Working together with the weather icons are the weather tendency indicators (the upward
and downward arrow located near the Weather girl). When the indicator points upwards, it
means that the air-pressure is increasing and the weather is expected to improve, but when
indicator points downwards, the air-pressure is dropping and the weather is expected to
become worse.
Therefore, user may see how the weather has changed and is expected to change. For
example, if the indicator is pointing downwards together with cloudy icons, it means that the
last noticeable change in the weather was when it was sunny (the sunny icon only).
Therefore, the next change in the weather will be the cloudy icons since the indicator is
pointing downwards.
Note: Once the weather tendency indicator has registered a change in air pressure, it will
remain permanently visualized on the LCD.
DISPLAY OF INDOOR MAXIMUM AND MINIMUM RECORDS:
1.
In normal display mode, press the MIN/ MAX button three times. The maximum indoor
temperature and humidity will be shown. Also the date and time of recording this
temperature will be displayed.
2.
Press the MIN/ MAX button once more to display the minimum indoor temperature
and humidity. Also the date and time of recording this temperature will be displayed.
RESETTING THE INDOOR MAXIMUM/ MINIMUM RECORDS
1.
In normal display mode, press the MIN/ MAX button to advance to the MIN/ MAX
display.
2.
Press and hold the SET key for about 3 seconds; this will reset all indoor minimum
and maximum data recorded to the current time, date, temperature and humidity. The
max/ min temperature of the currently selected outdoor channel will also be reset at
the same time.
DISPLAY OF OUTDOOR MAXIMUM AND MINIMUM RECORDS:
1.
In normal display mode, press the CH/ + button to select the desired channel. The
channel ID will be displayed above the outdoor temperature reading.
2.
Press the MIN/MAX button, the max temperature of the selected channel will be
displayed. Also the date and time of recording this temperature will be displayed.
3.
Press the MIN/MAX button once more, the min temperature of the selected channel
will be shown. Press the ALM button to go back to the normal display mode.
37
39
DISPLAY OF TEMPERATURE AND HUMIDITY READINGS:
INDOOR TEMPERATURE
The indoor temperature and humidity are measured automatically and displayed on the
fourth section of the LCD.
Indoor Relative
Humidity %
OUTDOOR TEMPERATURE:
The last LCD section shows the outdoor temperature, a reception symbol and a channel
number under the temperature will also show if more than one transmitter has been used.
Outdoor
Reception
Symbol
Transmitter Identification No. (only shown
when more than one transmitter is used)
RESETTING THE OUTDOOR MAXIMUM/ MINIMUM RECORDS
Note: It is required to reset the outdoor MAX/MIN temperature records of different channels
separately.
1.
In normal display mode, press the CH/ + button to select a channel (1, 2 or 3). The
channel ID will be displayed above the outdoor temperature reading.
Note: The transmitter number will only be displayed if more than one transmitter is applied.
2.
Press the MIN/ MAX button once. The max icon will be displayed.
3.
Press and hold the SET button for about 3 seconds; this will reset all outdoor
minimum and maximum temperature recorded to the current time, date and
temperature.
Note: The max/ min temperature records of the indoor channel will also be reset at the same
time.
SUNRISE/ SUNSET/ SUN DURATION TIME:
Sunrise/ sunset
display
Indoor
Temperature
in °F
Outdoor temperature
in F
Maximum icon
38
Sunrise time/ Sunset
time/ Sun duration time
Short form of City
name (For example,
JFK - New York)
40

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tx29u-it

Table of Contents