Impex MARCY MWM-1509 Owner's Manual page 14

STEP 4 (See Diagram 4 & Cable Loop Diagram)
A.) Attach the 122" Upper Cable (#40) to the open bracket underneath the front of
Upper Frame (#8).
B.) Attach a Pulley (#49) to the open bracket. Secure it with one M10 x 1 ¾" Allen
Bolt (#75), two Ø ¾" Washers (#86), and one M10 Aircraft Nut (#90). Note: The
Ball Stopper on the Cable should be underneath the Frame and Pulley.
C.) Draw the Cable towards the back of the machine to the open bracket under the
Upper Frame. Repeat Procedure B above to install another Pulley.
D.) Draw the Cable around the Pulley then pull back to the open bracket on the back
of Front Press Base (#9).
E.) Repeat Procedure B above to install another Pulley.
F.) Draw the Cable around the Pulley then to the open bracket on the back of the
Upper Vertical Frame (#15). Repeat Procedure B above to install another Pulley.
G.) Draw the Cable around the Pulley then downward. Attach the Cable to two
Double Floating Pulley Brackets (#43). Install another Pulley. Let the bracket
hanging for now.
H.) Pull the Cable around the Pulley then upward to the open bracket underneath the
Upper Frame between the two Guide Rods. Install a Pulley to the bracket.
I.) Pull the Cable downward between the two Guide Rods to the Selector Rod (#47).
Fully thread the bolt at the end of the Cable into the top opening on the Selector
Rod.
J.) Connect the Lat Bar (#21) to a Short Chain (#64) with a C-clip (#70). Then
connect the Short Chain to the Upper Cable with another C-clip.
K.) Attach the Left Front Press Handle (#12) to the Left Butterfly (#10). Secure it with
one M10 x 2 1/8" Allen Bolt (#76) and Ø ¾" Washer (#86). Repeat the same
procedure to install the other side. Make sure the Handles are pointing toward
the back of the machine.
13