Table of Contents
Advertisement
CONSUMER INFORMATION SHEET FOR
PLAYGROUND SURFACING MATERIALS
The U.S. Consumer Product Safety Commission (CPSC) estimates that about 100,000 playground equipment-
related injuries resulting from falls to the ground surface are treated annually in U.S. hospital emergency rooms.
Injuries involving this hazard pattern tend to be among the most serious of all playground injuries, and have the
potential to be fatal, particularly when the injury is to the head. The surface under and around playground equipment
can be a major factor in determining the injury-causing potential of a fall. It is self evident that a fall onto a shock
absorbing surface is less likely to cause a serious injury than a fall onto a hard surface. Playground equipment should
never be placed on hard surfaces such as concrete or asphalt and while grass may appear to be acceptable it may
quickly turn to hard packed earth in areas of high traffic. Shredded bark mulch, wood chips, fine sand or fine gravel are
considered to be acceptable shock absorbing surfaces when installed and maintained at a sufficient depth under and
around playground equipment.
The following table lists the maximum height from which a child would not be expected to sustain a life-
threatening head injury in a fall onto four different loose-fill surfacing materials if they are installed and maintained at
depths of 6, 9, and 12 inches. However, it should be recognized that all injuries due to falls cannot be prevented no
matter what surfacing material is used.
FALL HEIGHT IN FEET FROM WHICH A LIFE THREATENING HEAD INJURY
TYPE OF MATERIAL
Double Shredded Bark
Mulch
Wood Chips
Fine Sand
Fine Gravel
It is recommended that a shock absorbing material should extend a minimum of 6 feet in all directions from the
perimeter of stationary equipment such as climbers and slides. However, because children may deliberately jump from
a moving swing, the shock absorbing material should extend in the front and rear of a swing a minimum distance of 2
times the height of the pivot point measured from a point directly beneath the pivot on the supporting structure.
This information is intended to assist in comparing the relative shock-absorbing properties of various material.
No particular material is recommended over another. However, every material is only effective when properly
maintained. Materials should be checked periodically and replenished to maintain correct depth as determined
necessary for your equipment. The choice of a material depends on the type and height of the playground equipment,
the availability of the material in your area, and its cost.
This information has been extracted from the CPSC publications "Playground Surfacing - Technical Information Guide" and
"Handbook for Public Playground Safety:" Copies of these reports can be obtained by sending a postcard to the: Office of Public
Affairs, U.S. Consumer Product Safety Commission, Washington, D.C., 20207 or call the toll-free hot line: 1-800-638-2772.
WOULD NOT BE EXPECTED
6-INCH DEPTH
9-INCH DEPTH
6
6
5
6
12-INCH DEPTH
10
11
7
12
5
9
7
10
4
Hide quick links:
Advertisement
Table of Contents
