Page 1
NOTE: Please read all instructions carefully before using this product Table of Contents COMPETITOR BENCH Safety Notice CB-202 Hardware Pack Assembly Instruction Parts List Warranty Ordering Parts Model CB 202 Retain This Manual for Reference 06-29-07 OWNER'S MANUAL ® IMPEX INC.
ORDERING PARTS..................BEFORE YOU BEGIN ® Thank you for selecting the Competitor Bench CB-202 by IMPEX INC. For your safety and benefit, read this manual carefully before using the machine. As a manufacturer, we are committed to provide you complete customer satisfaction.
IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a piece of exercise equipment. Be sure to read the entire manual before you assemble or operate your machine. In particular, note the following safety precautions: 1.
Page 4
WRANING LABEL REPLACEMENT The warning label shown here have been placed on the Cross Brace. If the label is missing or illegible, please call customer service at 1-800-888-8899 for replacements. Apply the label in the location shown.
ASSEMBLY INSTRUCTION Tools Required Assembling the Machine: Two Adjustable Wrenches. NOTE: It is strongly recommended two or more people assembling this machine to avoid possible injury. STEP 1 (See Diagram 1) A.) Connect the two Upright Beams (#1) by a Cross Brace (#2) in the mid-span. B.) Secure each end of Cross Brace to each Upright Beam with two M10 x 2 ½”...
Page 7
STEP 2 (See Diagram 2) A.) Attach the Front Support (#5) to the Main Seat Support (#3). Secure it with one M8 x 1 5/8” Carriage Bolt (#22), Ø 5/8” Washer (#29), and M8 Aircraft Nut (#31). Do not tighten the Nut and Bolt yet.
Page 8
STEP 3 (See Diagram 3) A.) Attach the side-holes on the two Backrest Supports (#7) to the pivot on the Main Seat Support (#3). Place the other end of the Backrest Supports rest against the Backrest Adjustment Bar (#10). B.) Attach the Backrest Board (#9) to the Backrest Supports (#7). Secure it with four M6 x 1 3/8”...
Page 9
STEP 4 (See Diagram 4) A.) Attach the Leg Developer (#6) to the open bracket on the Front Support (#5). Secure it with one M10 x 2 3/8” Hex Bolt (#24), Ø ¾” Washer (#30), and M10 Aircraft Nut (#32). B.) Insert two Foam Tubes (#11) half way through the holes on the Leg Developer.
PARTS LIST KEY NO. DESCRIPTION Q’ty Upright Beam Cross Brace Main Seat Support Diagonal Support Front Support Leg Developer Backrest Support Seat Pad Backrest Board Backrest Adjustment Bar Foam Tube Bracket Ø ¾” End Cap Foam Roll 1 ½” Square End Cap Ø...
® IMPEX INC. LIMITED WARRANTY ® IMPEX Inc. ("IMPEX ") warrants this product to be free from defects in workmanship and material, under normal use and service conditions, for a period of two years on the Frame from the date of purchase. This warranty extends only to the original purchaser.