Ryobi 725rE Operator's Manual page 20

REPLACING THE SPARK PLUG
Use a Champion RDJ7Y spark plug (or equivalent).
The correct air gap is 0.020 inch (0.5 mm). Remove the
plug after every 50 hours of operation and check its
condition.
1. Stop the engine and allow it to cool. Grasp the plug
wire firmly and pull it from the spark plug.
2. Clean around the spark plug. Remove the spark plug
from the cylinder head by turning a 5/8 in. socket
counterclockwise.
3. Replace cracked, fouled or dirty spark plug. Set the
air gap at 0.020 in. (0.5 mm) using a feeler gauge
(Fig. 41).
CAUTION: Do not sand blast, scrape, or I
clean electrodes. Grit in the engine could
I
damage the cylinder.
4. Install a correctly gapped spark plug in the cylinder
head. Tighten by turning the 5/8 in. socket clockwise
until snug.
If using a torque wrench torque to;
110-120 in.,Ib. (12.3-13.5 Nora).
Do not over tighten.
0.020 in.
(0.5 mm|
t
---- Fig. 41 ................................
ACCESSORIES/REPLACEM ENT PARTS
2-Cycle Oil ............................. 147543
Spark Plug .............................. 610311
Replacement Line ........................ 181472
Replacement Line Cartridge ................ 181460
Inner Reel Spring ........................ 181465
Outer Spool ............................. 181457
Inner Reel .............................. 181464
Bump Knob
TM
........................... 181468
Fuel Cap ............................... 180000
Edger Blade ............................ 613223
Shoulder Strap .......................... 682075
CLEANING
WARNING: To avoid serious personal injury,
always turn your trimmer off and allow it to
cool before you clean or do any maintenance
on it.
Use a sman brush to clean off the outside of the unit.
Do not use strong detergents. Household cleaners that
• contain aromatic oils such as pine and lemon, and
solvents such as kerosene, can damage plastic housing
or handle. Wipe off any moisture with a soft cloth.
STORAGE
• Never store the unit with fuel in the tank where fumes
may reach an open flame or spark.
• Allow the engine to cool before storing.
• Store the unit locked up to prevent unauthorized use
or damage.
• Store the unit in a dry, well ventilated area..
• Store the unit out of the reach of children.
LONG TERM STORAGE
2,
3.
If the unit will be stored for an extended time, use the
following storage procedure.
1. Drain all fuel from the fuel tank and drain into a
container with the same 2-cycle fuel mixture. Do not
use fuel that has been stored for more than 60 days.
Dispose of the old fuel/oil mix in accordance to
Federal, State, and Local regulations.
Start the engine and allow it to run until it stalls.
This ensures that all fuel has been drained from the
carburetor.
Allow the engine to cool. Remove the spark plug
and put I oz. (30 ml) of any high quality motor oil or
2-cycle oil into the cylinder. Pull the starter rope
slowly to distribute the oil. Reinstall the spark plug.
NOTE: Remove the spark plug and drain all of the oil
from the cylinder before attempting to start the
trimmer after storage.
4. Thoroughly clean the unit and inspect for any loose
or damaged parts. Repair or replace damaged parts
and tighten loose screws, nuts or bolts. The unit is
ready for storage.
TRANSPORTING
• Allow the engine to cool before transporting.
• Secure the unit while transporting.
• Drain fuel from unit.
• Tighten fuel cap before transporting.
These replacement parts can be purchased from your
local authorized dealer.
20